E Missile and Its Performance - An Analysis
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
This study mainly deals with the design and structural analysis of missile motor body. This is to design three missile motor bodies with different dimensions and analyze them by applying three different materials for the corresponding loads, which act when two types of propellants are used and find the material with less deformation and better load bearing capability. The main aim of this study is structural analysis performed on the antitank guided missile MILAN 2T motor body, which was designed in NX for varying dimensions and thickness of three motor body designs and analyzed in the NX simulation by applying the loads imposed by two different propellants, namely double base and triple base propellants.
Authors and Affiliations
Praveen Kumar Kallepelli, K. Durga Rao, Sudhakar Uppalapati
Keywords
Related Articles
- EP ID EP655670
- DOI 10.24247/ijmperdaug201938
- Views 75
- Downloads 0
Fluid-Structure Interaction Analysis on Horizontal Wind Turbine Blade
The research and advancements in green-energy industries like wind energy system technology has gained an increased interest in twenty-first century due to the reduction of natural resources and thus requires the standar...
A Power Efficient Multiplier Architecture for FIR Filters used for Acoustic Models in Mechanical Diagnostics
Finite Impulse Response (FIR) channels are broadly utilized as a part of multi standard remote interchanges. The important pre requisites of channels are re configurability and low many-sided quality. This paper proposes...
Effects of Ultraviolet Radiation with and Without Heat on the Fatigue Behavior of Below-Knee Prosthetic Sockets
This work focused on below-knee (BK) prosthetic sockets, which have gained wide application due to the increasing number of patients with BK amputation as a result of terrorist attacks and life-threatening situations in...
Investigation of Machining Parameters By Using PVD Coated TiIAlLN
AISI D2 steel is the leading candidate material used in dies for the production of automobile products and electronic parts. The machinability of the material involves tool life, cutting forces, chip formation with less...
Studies on Mild Steel Particulates Reinforced Duralumin Composite Fabricated Through Powder Metallurgy Route
In the present study Duralumin(DA) based Mild Steel particles (MSp-6% wt. and 12% wt.) reinforced composite are fabricated by cold compacting the milled powders. The mechanically mixed powders are compacted in a die cavi...