Effect of Al doping on the structural and optical properties of SnO2 thin films elaborated by sol-gel technique
Journal Title: Journal of New technology and Materials - Year 2017, Vol 7, Issue 2
Abstract
In this study, the influence of increasing of the Al concentration on the structural and optical properties of SnO2 thin films were investigated. Pure and aluminum-doped SnO2 thin films were prepared by sol–gel deposition method on glass and Si (100) substrates at room temperature and then annealed at 550°C in air. The obtained films are characterized by X-ray diffraction (XRD), atomic force microscopy (AFM), and UV–Vis spectrophotometry techniques. A single-phase rutile polycrystalline structure is revealed by XRD. The AFM analysis show that the surface morphology changes with Al concentration. The un-doped and Al-doped SnO2 thin films are transparent (86% optical transmittance) in the near UV-Vis, and the optical band gap is influenced by Al doping level.
Authors and Affiliations
M. Khechba, A. Bouabellou, F. Hanini, S. Touati
The barrier height and the series resistance of Ag/SnO2/Si/Au Schottky diode determined by Cheung and Lien methods
Electronic parameters of Ag/SnO2 /Si/Au Schottky diode (SD) determined by Cheung and Lien methods are extracted using the current-voltage (I-V) and the capacitance-voltage (C-V) characteristics. Such SD is fabricated by...
Assessing Vulnerability of groundwater with GOD model: a case study in Oran Sebkha basin - Algeria
The vulnerability of groundwater is a relative, non-measurable and dimensionless property, which is based on the concept that some land areas are more vulnerable to groundwater contamination than others. Most groundwater...
Chemical and isotopic characterization of the thermal waters of Hammam Skhouna Algeria
A series of chemical and isotopic analyses (O-18 and H-2) of aquifers performed in the Hammam Sokhna area, a large sedimentary basin located in southern Setif, filled with Mio-Plio-Quaternary deposits, which rest on Jura...
Comparison between the microstructural, morphological, mechanical and tribological characteristics of nanocrystalline Ni and Ni-Co electrodeposited coatings
For improving the wear resistance of steel used commonly in industry, nanocrystalline nickel and nickel-cobalt coatings are electrodeposited on A60 steel substrate in a modified Watts bath. The observation of the coating...
The effect of sliding speed and normal load on the friction and wear behavior of TiO2 thin films
The tribological behavior of TiO2 thin films was investigated against test parameters. The friction coefficient under different normal loads, sliding speeds, and numbers of cycles was studied using a micro-scratch tester...