Effect of combinative cooled addition of strontium and aluminium on mechanical properties AlSi12 alloy
Journal Title: Journal of Achievements in Materials and Manufacturing Engineering - Year 2017, Vol 1, Issue 83
Abstract
Purpose: The study was to determine the mechanical properties of hypo-eutectic silumin AlSi12 modified with Sr or Al-Sr alloy slow or fast cooled and in the form of a strip or powder. Design/methodology/approach: The experiment performed on EN AB-AlSi12 hypoeutectic alloy. Aluminium and strontium was melted and next fast cooled to room temperature or cooled on a metal plate at rates about 200°C/s. This enabled to produce a different components, which were powdered immediately before adding to the alloy or used as a strip. The scope of this paper was to verify the cooling effect of Sr-Al modifiers and its form (powder or strip) on the microstructure and mechanical properties the AlSi12 alloy. Findings: The use of fast cooled Al-Sr alloy in the modification process and/or powdered alloy contributed to a further increase mechanical properties AlSi12 alloy. Research limitations/implications: The modification alloys with fast cooled powdered modifier are attractive for future research. Practical implications: Widely presented books and research papers on the silumin treatment give not a lot of contents on the effect treatment fast cooled alloy in the form of a strip or powder. Originality/value: The original value of the paper is comparison Sr and Al-Sr alloy modifiers slow and fast cooled and used as a powder or strip.
Authors and Affiliations
T. Lipiński
Keywords
Related Articles
- EP ID EP226106
- DOI 10.5604/01.3001.0010.5134
- Views 86
- Downloads 0
Microstructure and mechanical properties of the Sanicro 25 steel after ageing
Purpose: The purpose of the research was to determine and analyse the changes in the microstructure and mechanical properties of the Sanicro 25 steel in the as-received condition and after ageing at 600, 650 and 700°C fo...
Comparison of the structure and topography of selected low friction thin films
Purpose: The purpose of this article is to characterize and compare the structure, mechanical and tribological properties of low friction DLC and TiC thin films deposited on the austenitic steel X6CrNiMoTi17-12-2 substra...
Surface topology of friction pairs of A390.0 alloys
Purpose: In the paper, geometric structure of the surface of A390.0 alloy, manufactured using various methods are presented, in combination with EN-GJL-350 cast alloy, which corresponds to parameters used in combustion e...
Power control of a wind energy based on a DFIG by sliding mode approach and pitch angle optimal control by genetic algorithm
Purpose: In this paper, a regulate of a variable wind energy conversion system, based ona doubly fed induction generator DFIG is proposed, the system we considered is controlledto generate maximum energy while minimizing...
About weldability and welding of Al alloys: case study and problem solving
Purpose: Among many disciplines within engineering, welding is probably one of the most inexact – rather more of an art than a science. As weldment is meant the complete joint comprising the weld metal, heat affected zon...