Effect of layer number on bending behavior of 3D spacer composite plates produced with different methods
Journal Title: Firat University Journal of Experimental and Computational Engineering - Year 2022, Vol 1, Issue 1
Abstract
In this study, the three-point bending behavior of laminated composite plates reinforced with three-dimensional (3D) spacer fabric was experimentally investigated. Composite plate production was carried out using hand lay-up and vacuum infusion (VARI) method. Three-point bending test results of composite plates produced as a single layer were experimentally compared. Afterwards, composite plates with 2 and 3 layers were obtained by vacuum infusion method and load displacement graphs were obtained by subjecting them to three-point bending test. There was no significant difference between the load carrying capacities of the single-layer composite plates produced by hand lay-up and vacuum infusion method in the three-point bending test. According to the three-point bending test, the maximum load obtained 105 N in hand lay-up production is 8% greater than the vacuum infusion method. While the maximum load was 602 N in the plate produced in the 2-layer vacuum infusion method, it was obtained as 923 N in the 3-layer.
Authors and Affiliations
Serkan ERDEM, Mete Onur KAMAN, Mustafa GÜR
A novel design for concrete culverts absorbing explosive energy from homemade explosives
With the increasing number of terrorist attacks for the last 40 years, terrorist organizations have devised various attack tactics. One of these tactics is to attack by placing homemade explosives inside culverts that ar...
Investigation of some thermophysical properties of Asphodelus aestivus reinforced polyester composite
In this research, both environmentally friendly and economical composites have been produced by using biomass wastes in unsaturated polyester. The use of renewable biomass wastes as a filler in unsaturated polyester is r...
Using computational fluid dynamics for wave generation and evaluation of results in numerical wave tank modelling
In this paper, computational modeling of wave generation and evaluation of results are given. The analysis of Computational Fluid Dynamics is performed in the ANSYS Fluent module. The model of numerical analysis is made...
Detection of brain tumor with a pre-trained deep learning model based on feature selection using MR images
One of the most dangerous diseases in the world is a brain tumor. A brain tumor destroys healthy tissue in the brain and then multiplies abnormally, causing increased internal pressure in the skull. This can lead to deat...
Damage Assessment of Masonry Structures in Adıyaman Province After Kahramanmaraş Earthquakes (February 6, 2023)
According to the data of the Disaster and Emergency Management (AFAD) Earthquake Department; On February 6, 2023, at 4.17 and 13.24 Turkey time, earthquakes with magnitudes of 7.7 and 7.6 (Mw) occurred, respectively, wi...