Effect of Parameters of Selection and Replacement Drilling Bits Based on Geo-Mechanical Factors: (Case Study: Gas and Oil Reservoir in the Southwest of Iran)
Journal Title: American Journal of Engineering and Applied Sciences - Year 2016, Vol 9, Issue 2
Abstract
Effect of Parameters of Selection and Replacement Drilling Bits Based on Geo-Mechanical Factors: (Case Study: Gas and Oil Reservoir in the Southwest of Iran) Arzhang Nabilou DOI : 10.3844/ajeassp.2016.380.395 American Journal of Engineering and Applied Sciences Volume 9, Issue 2 Pages 380-395 Abstract The purpose of the present study was to explore the effect of drill bit selection parameters on enhanced oil and gas recovery fin Iranian oil and gas fields. In this study, many methods and parameters were discussed. These parameters are practically tested on many wells in southwestern field of Iran. Out of common drill bit selection methods, length unit drilling cost is the most popular one owing to the direct investigation of economic parameters related to the performance of the drill bit. However, previous studies conducted in one of the southern gas fields of Iran showed that this method’s results do not yield the optimal drill selection and geology since it fails to evaluate drill bits used in various drilling conditions. To address this problem, some methods have been introduced as complementary of this method which allow comparing various drill bits. In the present work, it was illustrated that using geo-mechanical factors are ideal complements for the method of length unit drilling cost in Iran. Copyright © 2016 Arzhang Nabilou. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited. http://thescipub.com/abstract/10.3844/ajeassp.2016.380.395
Authors and Affiliations
Arzhang Nabilou
Keywords
Related Articles
- EP ID EP203650
- DOI 10.3844/ajeassp.2016.380.395
- Views 59
- Downloads 0
Optimization of a Combined Approach for the Treatment of Carbide Slurry and Capture of CO2
Abstract The aim of this study is to evaluate the potential use of electrocoagulation in the treatment of carbide slurry, a wastewater generated during the production of acetylene, and in the capture of carbon dioxide....
Outlook of Municipal Solid Waste in Bogota (Colombia)
Abstract The Municipal Solid Waste is a new target of the municipal government because their negative consequences if the management is inadequate (health diseases, pollution, etc.); In Latin America, the most frequency...
Polyethylene Pipeline Bending Stresses at an Installation
Polyethylene Pipeline Bending Stresses at an Installation Anatoly Serebrennikov, Daniil Serebrennikov and Zufar Hakimov DOI : 10.3844/ajeassp.2016.350.355 American Journal of Engineering and Applied Sciences Volume 9,...
Numerical Study of Natural Convection in a Square Porous Cavity Thermally Modulated on Both Side Walls
Abstract The numerical study of natural convection in a square porous cavity saturated by a Newtonian fluid is presented in this study. The vertical walls are subjected to temperatures varying sinusoidally in time and p...
High-Speed for Data Transmission in GSM Networks Based on Cognitive Radio
Abstract This paper mainly studies data transmission DT rate in the modern communication systems. Increasing the need to improve the sensitivity of the control systems to detect low signals weak capacity density in view...