Effect of pouring temperature on the Lost Foam Process
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 3
Abstract
In this study, the analysis of the influence of the pouring temperature on manufacture process of castings by the Lost Foam method was introduced. In particular, numerical simulation results of effect of silumin and grey cast iron pouring temperature on pouring rate and gas gap pressure were analyzed. For simulating investigations of the Lost Foam process introduced mathematical model of the process was used. For calculations, the author's own algorithm was applied. The investigations have proved that with increasing pouring temperature the pouring rate increases, while pressure in the gas gap are decreasing. The author’s own investigations showed a more significant effect of the silumin pouring temperature than grey cast iron pouring temperature on the lost foam process.
Authors and Affiliations
T. Pacyniak, R. Kaczorowski
Keywords
Related Articles
- EP ID EP72372
- DOI -
- Views 98
- Downloads 0
Assessment of the possibility of utilisation of used ceramic moulds originated from the investment casting technology
Review of wastes generated by investment casting technology and discussion on possibilities of disposal of the largest quantity waste from this technology - used ceramic mould is presented in the paper. Preliminary exami...
Studies of structural and mechanical properties of aluminum skeleton castings
Skeleton castings were manufactured in accordance to elaborated production technology. The subject of the research was the microstructural analysis of non - monolithic castings. Analysis of metallographic specimens and q...
Application of the Pareto chart and Ishikawa diagram for the identification of major defects in metal composite castings
This author discusses the use of selected quality management tools, i.e. the Pareto chart and Ishikawa fishbone diagram, for the description of composite casting defects. The Pareto chart allows to determine defect prior...
Unconventional methods of reclamation of used moulding sands
Analysis of the literature provides information on a constant search for new ways of regenerating of moulding sand deprived disadvantages of existing solutions, especially in the case of low efficiency of regeneration of...
Influence of refining process on the porosity of high pressure die casting alloy Al-Si
This study presents research results of the influence that refining and transfer of AlSi12S alloy on the porosity of high pressure diecastings. Tests were conducted under production conditions of Die-casting Foundry META...