Effect of Rotatory Inertial And Damping Coefficient on The Transverse Motion of Uniform Rayleigh Beam Under Moving Loads of Constant Magnitude
Journal Title: American journal of Engineering Research - Year 2018, Vol 7, Issue 1
Abstract
In this work, the effect of rotatory inertial and damping co-efficient on the transverse motion of Rayleigh beam subjected to moving loads of constant magnitude is investigated. The solution techniques employed is based on the Fourier Sine Transform, Laplace Integral Transformation and Convolution Theorem. It is observed that, the amplitude of deflection of the beam under the influence of moving load of constant magnitude decreases with an increase in the value of the rotatory inertial and damping co-efficients. Also as the values of the other structural parameters such as shear modulus, foundation modulus and axial force increases, the amplitude of vibration of the beam decreases. Finally, it is observed the effect of rotatory inertial is significant compared with damping co-efficient effect.
Authors and Affiliations
Jimoh, A, Ajoge, E. O.
Keywords
Related Articles
- EP ID EP396116
- DOI -
- Views 67
- Downloads 0
Determination of Power Flow in PQ Bus System By Using Gauss Seidel Method
Power flow analysis is the backbone of power system analysis and design. They are necessary for planning, operation, economic scheduling and exchange of power between utilities. The principal information of power flow an...
Modeling of Internal Erosion and Initiation of Piping Phenomenon in a Dam
The initiation of a piping phenomenon which may occur under the dam is modeled. The model constructed to represent this problem is bi-dimensional. It combines the Darcy equation, the mass conservation equation for the fl...
Monitoring liquid Dropout for Investigating Liquid Loading in Gas Wells
This paper presents a dynamic simulation approach to monitoring liquid dropout in gas wells for investigating liquid loading of a fluid flowing in mist flow regime. It involves incorporating an event location property in...
Mathematical Modeling of the Effect of Different Parameters on Spring Back in Sheet Metal Formability Process
In the study, bending process was performed on the AISI304 sheet metals at different thicknesses (2 mm, 3 mm, 4 mm, and 5 mm) and different punch type radii (R2 mm, R4 mm, R6 mm, and R8 mm) by using air V bending techniq...
Thermal water characteristics and their impact in maize production quality, in Diber area
The objective of this study has been the impact of thermal water in Peshkopi in maize characteristics and quality of its production in the area used this water for irrigation. The study period there has been during years...