Effect of thickness of refractory coating on the Lost Foam Process
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 3
Abstract
The analysis of the influence of the thickness of refractory coating on the production process of casts in the Lost Foam process was introduced in the work. It was conducted in the peculiarity the analysis simulating investigations the influence the coating thickness on the pouring rate, pressure in the gas gap and gas gap size. For simulation tests of the Lost Foam process, a mathematical model presented in this study was used. For calculations, the author's own algorithm was applied. Investigations have proved that with increasing thickness of coating the pouring rate decreases, while pressure in the gas gap and the size of the gap are increasing. The author’s own investigations have proved a very significant effect of the coating thickness on the Lost Foam process, and specially on the mould pouring rate.
Authors and Affiliations
T. Pacyniak
Keywords
Related Articles
- EP ID EP72085
- DOI -
- Views 114
- Downloads 0
Effect of T6 heat treatment on tensile strength of EN AB-48000 alloy modified with strontium
Among alloys of non-ferrous metals, aluminum alloys have found their broadest application in foundry industry. Silumins are widely used in automotive, aviation and shipbuilding industries; as having specific gravity near...
The solidification during flow of composite suspension in the permanent mould
The presented work presents the influence of graphite particles on the solidification kinetics of metal suspension based on AlSi10Mg alloy during the die cavity filling. In order to examine this problem, the measurements...
Influence of the microstructure and loads on tribological properties of G155CrNiMo4-3-3 cast steel
Materials for mill rolls, fulfilling high requirements due to difficult exploitation conditions, are cast steels of adamite grade. Those are cast steels of pearlitic matrix with uniformly distributed cementite precipitat...
Three-dimensional numerical model of solidification with motion of the liquid phase
The paper presents numerical modeling of solidification process with convective motion of the liquid phase, generated both in the liquid and mushy zones. The transition region between the areas filled with liquid and sol...
Use of the JM-SPC software to statistical control of high pressure die casting production-attribute valued data type
A new version of the JM-SPC computer program written by J. Mutwil in Delphi for statistical control of production processes is presented. All changes have been by users suggestions caused. For the attribute valued data t...