Effects of Velocity-Slip and Viscosity Variation in Squeeze Film Lubrication of Two Circular Plates
Journal Title: Tribology in Industry - Year 2013, Vol 35, Issue 1
Abstract
A generalized form of Reynolds equation for two symmetrical surfaces is taken by considering velocity-slip at the bearing surfaces. This equation is applied to study the effects of velocity-slip and viscosity variation for the lubrication of squeeze films between two circular plates. Expressions for the load capacity and squeezing time obtained are also studied theoretically for various parameters. The load capacity and squeezing time decreases due to slip. They increase due to the presence of high viscous layer near the surface and decrease due to low viscous layer.
Authors and Affiliations
R. R. Rao, K. Gouthami, J. V. Kumar
Keywords
Related Articles
- EP ID EP135692
- DOI -
- Views 86
- Downloads 0
Fundamental Study on No-lubricating Friction Characteristics Due to Anisotropy of Surface Properties Applied to Differential Gear
The solid frictional characteristics of surface roughness in combination with anisotropy were systematically investigated through linear reciprocating sliding tests on planar surfaces with no lubrication. Four types of t...
A Critical Review of Measures for an Effective Application of Nano-Structured Coatings in Milling
The evolution of the coating deposition technologies led, among others, to the production of nano-structured coatings. Such coatings are often deposited on cutting tools since they contribute to an impressive enhancement...
Effect of Manganese Additions and Wear Parameter on the Tribological Behaviour of NFGrey (8) Cast Iron
The effect of manganese and wear parameter on the abrasive wear behaviour of NFGREY8 cast iron composition under dry lubrication conditions was investigated. The wear parameters studied are sliding speed, applied load,...
Cassava Leaf Nanoparticles (CLNPs) as a Potential Additive to Anti-Corrosion Coatings for Oil and Gas Pipeline
Characterization of synthesized cassava leaf nanoparticles (CLNPs) was carried out using SEM/EDX and Gwyddion software, XRD and TEM for cassava leaves (CL) ball milled at 36, 48, 60 and 72 hours. The morphological study...
Experimental Determination of Contact Area
The main goal of this article is to experimentally evaluate the contact area and to compare the measured results with the different contact model theories. The experiment takes advantage of the electrical contact resisti...