Electrical Energy Harvesting From Mechanical Pressure of Vehicles Using Piezoelectric Generators
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 2
Abstract
The paper is intended to forecast the present condition of energy utilization and the usage of the resources in the generation process. According to International Energy Agency’s New Policies Scenario demand of global electricity consumption will grow by almost 80% by 2040.The contribution of renewable resources in accordance with power generation will increase up to 33% by 2040. The rapidly-increasing contribution and importance of renewable resources in power generation field has led to developments of several sustainable technologies. It’s an opportunity to generate a clean and green energy using the resources what we have in present. Piezoelectricity is a very old discovery not much been developed yet and not much trusted due to its inefficiency. The recent research and development in the electronics sector and its applied streams of electricity production and storage techniques have made possible to capture the energy that was always unnoticed so far. Energy which is in fact invisible energy which can be generated by applying pressure on specific substances with varying pressure produced by the on road moving vehicles. Thus, making the Piezoelectric effect a sensible concept. It is a new concept and has greater prospects in the maintainable energy circles. It is relatively inexpensive and easy to install, and recycles otherwise wasteful forms of energy. Here we mention that the conditions presented are approximations and recent practices have shown that greater amount of energy can be generated from such practices.
Authors and Affiliations
Ashish Dakhole, Amol Boke
Keywords
Related Articles
- EP ID EP387076
- DOI 10.9790/1676-1202024649.
- Views 275
- Downloads 0
Comparitive Analysis of Fuzzy Based MPPT for Boost and SEPIC Converter Topologies for PV Application
This paper proposes the Maximum Power Point Tracking based on Fuzzy logic control for PV System.MPPT is required to extract maximum power corresponding to specific operating point. The output power of PV System is depend...
Influence of Optimal Network Reconfiguration of Electric Power Distribution Feeders on Power Loss Minimization: A Comprehensive Review
The aim of reconfiguring the electric power distribution network under normal operating conditions is to reduce the total active power losses of the network or to balance the load of the system’s feeders which is an impo...
Substation Earthing Design
Successful operation of entire power system depends to a considerable extent on efficient and satisfactory performance of substations. Hence substations in general can be considered as heart of overall power system. In a...
Optimal Reactive Power Compensation in Transmission Networks By TCSC Using Particle Swarm Optimization
Increased demand for electrical energy and free market economies for electricity exchange, have pushed power suppliers to pay a great attention to quality and cost of the latter, especially in transmission networks. To r...
Design And Implementatio Of Multiloop Controllers For MIMO System
The objective of this paper is to design controllers for the TITO (Two Inputs and Two Outputs) system, the nonlinear system considered is quadruple tank process. In order to design the controller initially the work is st...