Enhanced Magnetic Squareness in Manganese-Bismuth Mechanical Alloys Incorporating Magnesium Oxide
Journal Title: Materials Science-Medžiagotyra - Year 2019, Vol 25, Issue 2
Abstract
Manganese-bismuth (MnBi) mechanical alloys have been under development for novel permanent magnets without rare-earth elements. The ball-milling of bismuth (III) oxide and manganese powders in this work leads to soft magnetic MnBi alloys with rod-like MnO impurity and highly unbalanced compositions. Interestingly, the introduction of magnesium (Mg) as reducing element during the milling gives rise to unique magnetic properties. The obtained MnBi alloys incorporating plate-like MgO has an enhanced magnetic squareness but minimal coercive field. The magnetic squareness remains high after the heat treatment and washing. The washing in ammonia also brings about a balanced composition between Mn and Bi.
Authors and Affiliations
Thanida CHAROENSUK, Chitnarong SIRISATHITKUL, Upsorn BOONYANG, Pongsakorn JANTARATANA
Keywords
Related Articles
- EP ID EP581467
- DOI 10.5755/j01.ms.25.2.19710
- Views 26
- Downloads 0
Dependence of Electrical and Optical Properties of Sol-gel-derived SnO2 Thin Films on Sb-substitution
In the present work, Sb-doped SnO2 (ATO) thin films were deposited on Si substrates by spin-coating method and the influence of Sb-doping on surface roughness, structural, optical and electrical properties has been inves...
Establishment of Prediction Model of Microstructure and Properties of 3003 Aluminum Alloy during Hot Deformation
The 3003 aluminum alloy was deformed by isothermal compression in the range of deformation temperature 300 – 500 ℃ at strain rate 0.0l – 10.0 s-1 with Gleeble-1500 thermal simulator. A constitutive equation is establish...
Ag-induced a New Raman Mode in ZnO Microrods
The chemical vapor deposition technique was used to prepare the Ag doped ZnO microrods, which were located on Si substrates at two different positions. The scanning electron microscopy revealed that the samples have a cl...
Experimental Study on the Thermal Decomposition of Two Nitrocellulose Mixtures in Different Forms
In order to ensure the safety of nitrocellulose (NC) mixtures in storage, transportation and usage, it is necessary to study the thermal stability of NC mixtures. In the present study, the thermal decomposition of two co...
Evaluation of the Effect of Thermo-mechanical Treatment on the Resistance of Commercial OSB to Decay Fungi
The chemical treatment of wood has been widely used in combating rot fungi. However, it’s a process that involves the insertion of chemical agents, which are subject to leaching when exposed to weathering. In this contex...