Ergonomic assessment of brake and accelerator mechanisms of MF285 and MF399 tractors using electromyography method
Journal Title: Journal of Agricultural Machinery - Year 2016, Vol 6, Issue 1
Abstract
Introduction: Too many people are working in the agricultural sector and therefore, pay more attention to the safety and health at work in the agricultural sector is important. This issue is more important in developing industrial countries where the level of the ergonomic working condition is less than that of developed countries. Attention to ergonomic condition of agricultural machinery drivers is one of the goals of agricultural mechanization. Therefore, in this study the ergonomic conditions of brake and accelerator mechanisms for MF285 and MF399 tractor's drivers were investigated using a new method. Materials and Methods: 25 people were selected for experiment. The electrical activity of Medialis gastrocnemius, Lateralis gastrocnemius, Vastus medialis, Vastus lateralis, Quadratus Lumborum and Trapezius muscles of drivers before and during pressing the pedal and after rest time were recorded using Biovision device. Measurements were performed for each person on each muscle 30 seconds before pressing the pedal, 60 seconds after pressing the pedal and after 60 seconds of rest. For all drivers, the muscles on the right side (brake and accelerator side) have been selected and tested. The measurements were performed in compliance with appropriate time intervals between the measurements. Results and Discussion: Ergonomic assessment of brake pedal: The results showed that the RMS electrical activity of muscles of Vastus medialis and Medial gastrocnemius, during 60 seconds braking were 2.47 and 1.97. So, Vastus medialis and Medial gastrocnemius had the highest stress during pressing the MF399 tractor's brake pedal. Moreover, the Medial gastrocnemius and Lateral gastrocnemius with RMS electrical activity ratio of 2.47 and 1.74 had the highest RMS electrical activity ratio respectively, during 60 seconds braking compared to before braking of MF285 tractor. The comparison of results showed that the Vastus medialis and Trapezius had the higher stress during braking of MF285 tractor than that of MF399 tractor, while, muscles of Medialis gastrocnemius, Lateralis gastrocnemius, Vastus lateralis, Trapezius and Quadratus Lumborum showed the lower stress during braking of MF285 tractor. Ergonomic assessment of accelerator: During 60 seconds pressing the accelerator pedal for MF285 the RMS electrical activity of muscles of Quadratus Lumborum and Medialis gastrocnemius were 3.25 and 2.15. So, these muscles had the highest stress during pressing the accelerator pedal for MF285. Drivers of MF399 tractor experienced high stress in their Vastus lateralis and Lateralis gastrocnemius muscles during pressing the accelerator pedal. The results highlighted that for all muscles, except Vastus lateralis, the electrical activity ratio during pressing the accelerator pedal of MF285 tractor were higher than that for MF399 tractor. Conclusions: To conclude, Vastus medialis and Trapezius had the higher stress during braking of MF285 tractor than that of MF399 tractor, while, muscles of Medialis gastrocnemius, Lateralis gastrocnemius, Vastus lateralis, Trapezius and Quadratus Lumborum showed the lower stress during braking of MF285 tractor as compared with the other model of tractor. Generally in all muscles, except Vastus lateralis, the electrical activity ratio during pressing the accelerator pedal of MF285 tractor was higher than that for MF399 tractor and the drivers need more effort while pressing the accelerator pedal and drivers of this tractor had adverse condition while using the accelerator mechanism. Acknowledgements: The research leading to these results has received funding from the Ferdowsi University of Mashhad, Iran, is gratefully acknowledged. Gratitude also goes to Dr. Mohammad Hossein Abbaspour-Fard, Hossein Fallahi and Mehdi Mahjour for their guidance and support throughout parts of this research.
Authors and Affiliations
A. Nikkhah,B. Emadi,M. Khojastehpour,S. R. Attarzadeh Hossini,
Keywords
Related Articles
- EP ID EP717784
- DOI -
- Views 40
- Downloads 0
A Study of the Shrinkage Changes and Mathematical Modeling of Garlic (Allium sativumL.) During Convective Drying
Garlic (Allium sativumL.) is one of the most important Allium spice. From an economic point of view, the dried garlic slices are valuable products. In this research, garlic slices as a thin layer were dried in a laborato...
Development of a Grapevine Pruning Algorithm for Using in Pruning
Introduction Great areas of the orchards in the world are dedicated to cultivation of the grapevine. Normally grape vineyards are pruned twice a year. Among the operations of grape production, winter pruning of the bushe...
Introducing a Strategy for Selection of Plowing Systems Using Hybrid SWOT-AHP Method (Khodabandeh, Zanjan)
For improvement or change in a plowing system, it is crucial that all important parameters to be taken in account. Recommendation of a tillage system should receive supports from research data as well as from skilled far...
Testing and evaluation of a rototiller with new ridged blades
Introduction Recently, employment of rotary tillers has been expanded in gardens and small farms, especially in the northern of Iran. However using the L-shaped blades in the conventional rotary tillers have some problem...
Evaluation of the Energy Efficiency of a Solar Parabolic Collector Equipped with Phase Change Materials inside the Receiver Tube of a Desalination System
IntroductionWith increasing the world's population, the demand for supply water resources is also increasing. Nevertheless, climate change has severely impacted the accessibility of fresh water resources. Consequently, r...