Error analysis in obtaining scale factors with operational modal analysis and mass change
Journal Title: Revista Facultad de Ingeniería-Universidad de Antioquia - Year 2015, Vol 1, Issue 75
Abstract
In operational modal analysis, the accuracy obtained in the identification of modal parameters, on the one hand, and the expertise in the modification of mass used to alter the dynamic behavior of the structure, on the other, decisively affect the accuracy achieved in the estimation of the scaling factors. Through experimental tests and numerical calculations, both the experimental validation of the estimate of the error in the scaling factor due to errors in the mode of vibration and the analysis of the influence of the modal mass in the variation of the scale factor, have been carried out. From all the above, it is concluded that it is necessary to pay special attention to how to make and modify inertial increments, i.e. changes in mass.
Authors and Affiliations
Luis Manuel Villa-García
Keywords
Related Articles
- EP ID EP627955
- DOI 10.17533/udea.redin.n75a19
- Views 98
- Downloads 0
Effect of the functionalization of silica nanoparticles as a reinforcing agent on dental composite materials
The present study evaluated the effect of silica nanoparticle aggregation state on the reflectance and crystallinity of dental composite materials. Two types of silica nanoparticles (ca. 10 nm): Aerosil 200 non-funcional...
A two-stage decision support model for a retail distribution center location
This paper proposes a model to support the decision-making process of selecting the location of a distribution center for the retail sector. The model was structured in two stages to consider objective and subjective cri...
Cation and anion monitoring in a wastewater treatment pilot project
The purpose of wastewater treatment is water reuse. It reduces potable water consumption while preventing fresh water contamination. Water reuse schemes have already been successfully established in different locations....
Experimental characterization of thermal hydraulic performance of louvered brazed plate fin heat exchangers
Louvered fins are commonly used in compact heat exchangers to increase the surface area, turbulence, and initiate new boundary layer growth required to improve the heat transfer performance without a significant increase...
Band-Pass filters using OSRR cells
This paper presents the design process (including optimization and characterization) of a band-pass filter through the use of OSRR-structured meta-material cells over micro-strip substrates. The proposed design, which st...