ESTIMATION THE INFLUENCE THE TYPE OF FILLER ON THE RESISTANCE TO EROSIVE OF EPOXY COATING
Journal Title: Tribologia - Year 2010, Vol 232, Issue 4
Abstract
The paper presents influence of micro- and nanofillers on erosive wear of coatings modified with the use of these particles. Glass microspheres of differentiated diameter values not exceeding 30 μm were used as microfiller at a mass share of 10%; whereas, nanofiller copper particles of mean diameter 66 nm were used at a mass share of 3.5%. Copper nanoparticles caused the essential increase of the erosive resistance of the coatings modified with their use, since this resistance increase by 46% in comparison with the erosive resistance of unmodified coatings. It was primarily caused by the increase in the coating hardness, coating roughness reduction, and the increase of the dynamic storage modulus E’ of modified coatings. The composite coating consisting of epoxy layers modified with glass microspheres showed the lowest erosive resistance. It was probably caused by the higher roughness of the composite coating, the low resistance of microspheres to brittle cracking, and their weak bonding with epoxy material. Higher erosive resistance was obtained for a three-layer epoxy coating with interlayer modified with glass microspheres. It increased by 16%, compared with the erosive resistance of the unmodified coating.<br/><br/>
Authors and Affiliations
Danuta Kotnarowska
Keywords
Related Articles
- EP ID EP517396
- DOI -
- Views 64
- Downloads 0
ZWIĘKSZENIE NOŚNOŚCI ORAZ ZMNIEJSZENIE SIŁ TARCIA W SFERYCZNYCH MIKROŁOŻYSKACH HDD
Niniejsza praca przedstawia nową metodę obliczania sił tarcia występujących w ślizgowych hydrodynamicznych sferycznych mikrołożyskach HDD dysków komputerowych. Mikropowierzchnie mikrołożysk ślizgowych są powlekane cienką...
WPŁYW KONSTRUKCJI MECHANIZMU RÓWNOWODOWEGO NA ROZKŁAD OBCIĄŻEŃ W PRZEKŁADNI CYKLOIDALNEJ
W obiegowej przekładni cykloidalnej moment napędowy jest przekazywany na koła obiegowe za pośrednictwem wałka mimośrodowego z osadzonymi na nim łożyskami centralnymi. Do wyprowadzenia momentu obrotowego z kół obiegowych...
THE EFFECT OF THE EXPOSURE-IN-OIL ON THE CONTACT ANGLE OF THE POLYMERS FORMING SLIDING LAYERS IN HYDRODYNAMIC BEARINGS
Polymers used as the sliding layers of hydrodynamic thrust bearings are typically thermoplastics characterized by relatively high values of contact angles when compared with metals. Metals, including Babbitt, or other be...
INVESTIGATION METHODS FOR ROLLING BEARINGS IN TERMS OF CURRENT REQUIREMENTS FOR HIGH PERFORMANCE PRODUCTS
As a result of the development in machine design, progress investigation in rolling bearing production is necessary. The criteria for bearings dictate the production of bearings for specific applications. This requires a...
INFLUENCE OF BICYCLE BRAKE SYSTEM ON USERS SAFETY
In many big cities, for example, Silesia Conurbation, in order to limit the negative results of automotive vehicles operation, toll bicycle rental stations have been actuated. Their users are incidental persons. Therefor...