Evaluating An Electrical Discharge Machining Parameters With Using Titanium Nano Particle Mixed Dielectric Medium

Abstract

Electric discharge machining is un-conventional machining process. Electrical discharge machine is commonly used for machining for those materials which are cannot processed by conventional machining process. Electrical discharge machine parameters have a significant influence on machining characteristic like material removal rate (mmr) and tool wear rate (twr). In this paper, we compared with titanium powder and without titanium powder mixed diectric fluid used in material removal rate and tool wear rate. The piece used is inconel 718 and tool materials used brass electrode with current, pulse on time and flushing pressure was parameter.

Authors and Affiliations

D. Devendran, R. Boopathi

Keywords

Related Articles

Implementation of Electronic Nose with TGS Gas Sensors

Nowadays, requirements for detecting fresh milk from farms are restricted by traditional testing methods and expensive imported detecting instruments, which is going against the improvement of fresh milk’s quality. The...

A Novel Alternative Signal Generation for PAPR Reduction in OFDM using Shift Value Set for CSS

The implementation of the orthogonal frequency division multiplexing (OFDM) in a wireless communications domain has introduced the world a new communication model which can offer 100 Mbps speed with minimum disadvantage...

A Highly Intelligent into System to Monitor the Petrol flow the Petrol Tank

Petrol has become one of the most basic fuel requirements of every individual to run their day-to-day life. In a developing country like India, the total economy of the country depends on the petroleum products. At most...

Review of axial heat conduction effect in parallel flow microchannel heat exchanger

In this paper, a comprehensive review of available studies regarding axial heat conduction effect in parallel flow microchannels is presented and analyzed. Different articles are reviewed to identify the effect of axial...

Utilization of Waste Foundry Sand for Development of Eco-Friendly Low Cost Concrete

Now-a-day’s good quality natural river sand is not available easily; it is to be transported from a long distance. These resources are also exhausting at a very fast speed. So there is a need to find alternative source...

Download PDF file
  • EP ID EP24202
  • DOI -
  • Views 281
  • Downloads 10

How To Cite

D. Devendran, R. Boopathi (2017). Evaluating An Electrical Discharge Machining Parameters With Using Titanium Nano Particle Mixed Dielectric Medium. International Journal for Research in Applied Science and Engineering Technology (IJRASET), 5(5), -. https://europub.co.uk/articles/-A-24202