Evaluation of bit errors in different types demodulation discrete signals
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2015, Vol 0, Issue 63
Abstract
Introduction. The introduction describes the main characteristics of bit errors. These sources of bit errors in discrete channels. Also listed scientists who worked on the study opportunities monitoring bit error in discrete channels. The main purpose of the article is to conduct research and theoretical modeling of processes in discrete channels to control error measurement and forecasting parameter BER bit error depending on the signal/noise ratio. Theoretical analysis. A comparison of some types of digital modulation for effective use in systems transmitting information. Comparisons were made using the correlation function, power spectral density and distance between signals. It was proved that through this you can control the real value of bit error (BER) for each type of modulation. Important here is the dependence of the BER signal/noise ratio in the test communication channel. Determined that efficiency could be described bit error probability value of the output of the receiver, which is determined by the expression (4). Control parameters BER modulation in digital signals. At this paragraph the examples of control parameter BER at different modulation signals. The simulation results show that with an increase in the signal/noise bit error probability for different types of demodulation will decrease.
Authors and Affiliations
V. Kychak
Keywords
Related Articles
- EP ID EP308790
- DOI 10.20535/RADAP.2015.63.55-63
- Views 80
- Downloads 0
Student’s search for scientific and technical information
The possibilities that exist in the National Technical University of Ukraine "Kyiv Polytechnic Institute" for access to scientific and technical information in the fields of radio engineering and electronics are consider...
Choice of maintaining the resonant mode piezoelectric transducer
Analyzed the possible schemes for constructing ultrasonic generators with feedback, justified the choice of maintaining the resonant mode ultrasonic transducer.
Organisation of the life circle with account of the diagnostic system
It is shown, that at organization of life cycle of the radioelectronic device it is expedient to consider it as a subsystem, which is included into structure of the integrated system along-side with a subsystem carrying...
Identification of a semiconductor by facility of the nonlinear location on two harmonicas
In article is brought theoretical explanation of a experimentally received effect of the occurrence the negative differential resistance on the volt-ampere characteristic of a diode structures at influence upon them comp...
Enhanced C-band Coaxial Orthomode Transducer
Introduction. In this paper a novel configuration of wideband coherent coaxial OMT is presented. General Design of an Orthomode Transducer. The OMT consists of elements of 3 main types: a turnstile junction between coaxi...