EVALUATION OF THE HEATING SYSTEM FROM AN INJECTION MOLDING MACHINE
Journal Title: Journal of Engineering Studies and Research - Year 2018, Vol 24, Issue 2
Abstract
Injection is an economical process characterised through an increased productivity that leads, in the majority of cases, to finite pieces. The process of injection includes two distinctive phases, firstly, when the melting occurs, followed by the homogenisation and the creation of pressure; the process takes place in the plasticizing unity; coming next being the second phase that consists in the forming of the producs, in the cavity of the matrix. Regarding the main factors, the purpose of this paper was insuring a thermic regime as uniform as possible in order to obtain an appropriate plastifying process. To do this, with the help of a thermovision camera type Fluke Ti20, the thermic regime has been studied in the area of the plastifying cylinder, following the balancing of the heating resistances.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP660781
- DOI 10.29081/jesr.v24i2.292
- Views 62
- Downloads 0
A PROJECT MANAGEMENT GEOINFORMATICS UTILITY FOR HEALTH PROTECTION AND SANITARY DRAWINGS IN GREEN CONSTRUCTIONS - INFRASTRUCTURE WORKS
This research study analyses the life cycle assessment of different waste management techniques and sanitary drawings in landfilled waste treatment units' biotechnology at Community Health Centres design for the protecti...
COMPRESSIVE STRENGTH BEHAVIOUR OF CONCRETE PRODUCED USING OKIGWE RED LUMP STONE AS COARSE AGGREGATE
This study was carried out in order to ascertain if the Okigwe red lump stone, found in South-eastern Nigeria, could be used as coarse aggregate in making structural concrete. The maximum compressive strength values, obt...
VIBRATIONAL CASE STUDY FOR THE MOLD OSCILLATOR WITH HYDRAULIC SERVO SYSTEM
We have conducted sensitivity analysis to investigate the two-hydraulic-servo system for the mold oscillator. By modelling mathematical models for operating fluid flow to control a hydraulic cylinder, we changed design p...
ARTIFICIAL NEURAL NETWORK IN THE MODELLING OF THE EFFECT OF CHROMIUM DOPANTS ON THE MECHANICAL PROPERTIES OF AL-4%CU ALLOY
Artificial Neural Network (ANN) was used to model the effect of Chromium dopants on the mechanical properties duralumin (Al-4 %Cu). The results showed that the hardness, yield strength, and ultimate tensile strength incr...
A COMPARATIVE STUDY BETWEEN WATER-GAP AND AIR-GAP DISTILLATION MEMBRANES FOR REMOVAL OF SALTS FROM SALINE WATER BY DESALINATION METHOD
The water deficit for consumption in various daily activities is more pronounced especially in countries where rainfall is low or in those areas where water demand is higher than available resources. This paper is a comp...