Experimental and Analysis of Aluminum –CU Composite with Different Composition
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2016, Vol 4, Issue 8
Abstract
Copper-aluminum alloy or brass is known for their corrosion resistance. Brasses are stronger and more ductile than red and semi red brasses. They have high wear resistance and low friction coefficient against steel. The room temperature phase transformations are slow and usually do not occur; therefore these alloys are single phase alloys. The bronzes are used in bearings, gears, piston rings, valves and fittings. Aluminum is added to copper in order to improve mach inability and toughness. Aluminum increases the tensile strength and ductility of the copper, but the composition can be adjusted to balance mach inability and strength requirements. These alloys have a slow fail mechanism that temporarily prevents galling and seizing. In this project we have been added aluminum 10%, 20%, and 30% and which one is the best mechanical properties for automobile, aircraft component. In order that some experimental investigation conducting and finally concluded the best mechanical property in this composition.
Authors and Affiliations
B. Babu, Florence. T
Keywords
Related Articles
- EP ID EP22467
- DOI -
- Views 220
- Downloads 3
Recent Review on Trending Routing Protocols for Data Transmission
the route creation is done by inter-connecting the most adjacent nodes. Routing is the main issue in wireless network. The whole data delivery depends upon this because if the selected route is not appropriate or effici...
Design of Smart Health Monitoring and Alert System Using IOT
The advent of technology in the medical sector is tremendous as of today. Yet there are no any basic instruments which detect the temperature, blood pressure and pulse rate. This paper describes an electronic sensor net...
An Advanced Current Controller Implemented with ANN Technique for Three Phase Shunt Active Power Filter
This paper proposes an advanced control strategy to enhance performance of shunt active power filter (APF). The proposed control scheme requires only two current sensors at the supply side and does not need a harmonic d...
Estimating of long term concrete magnesium sulfate resistance up to 450 days depending on cement impact and water cement ratio
Sulfate attack is a complex form of deterioration that has damaged concrete structures throughout the world. Sulfate attack is particularly complex because the source of sulfates can be external or internal. The sulfate...
A Logical Spreadsheet Management System
Separate operators of the relational algebra were implemented in the spreadsheets. The ability to express relational queries and the users of spreadsheets can perform relational data transformations in the spreadsheet i...