Experimental Investigation and Parametric Analysis of Surface Roughness in CNC Turning Using Design of Experiments
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2014, Vol 4, Issue 9
Abstract
The manufacturing industries are very much concerned about the quality of their products. They are focused on producing high quality products in time at minimum cost. Surface finish is one of the crucial performance parameters that have to be controlled within suitable limits for a particular process. Surface roughness of machined components has received serious attention of Researchers for many years. It has been an important design feature and quality measure in machining process. There are a large number of parameters which affect the surface roughness. These include cutting tool variables, work piece material variables, cutting conditions etc. Therefore, prediction or monitoring of the surface roughness of machined components has been challenging and unexplored area of research The present work is therefore in a direction to integrate effect of various parameters which effect the surface roughness. Experiments were carried out with the help of factorial method of design of experiment (DOE) approach to study the impact of turning parameters on the roughness of turned surfaces. A mathematical model was formulated to predict the effect of machining parameters on surface roughness of a machined work piece. Model was validated with the experimental data and the reported data of other researchers. Further parametric investigations were carried out to predict the effect of various parameters on the surface research
Authors and Affiliations
Ranganath. M. S , Vipin
Keywords
Related Articles
- EP ID EP163036
- DOI -
- Views 134
- Downloads 0
Artificial Neural Networks (ANNS) For Prediction of California Bearing Ratio of Soils
The behaviour of soil at the location of the project and interactions of the earth materials during and after construction has a major influence on the success, economy and safety of the work. Another complexit...
Coverage Analysis of Various Wireless Sensor Network Deployment Strategies
Abstract: Recent years have seen a developing interest in deploying large number of sensor nodes that coordinate in a distributed fashion on data gathering and analysing. These nodes can be deployed over a Wireles...
Considering User Participation in Light Of level and Stages of Self-Selection in Architectural Design Process (ADP)
Presenting the new definition of self-selection in Architectural Design Process (ADP) needs to clarify the edges of this new concept versus the others, which exist in design area. Referring to conducting conten...
Numerical Analysis of Header Configuration of the Plate-Fin Heat Exchanger
Numerical analysis of a plate fin heat exchanger accounting for the effect of fluid flow maldistribution onthe inlet header configuration of the heat exchanger is investigated. In this analysis , it was found that fl...
Optimization of WEDM Process Parameters on Titanium Alloy Using Taguchi Method
This paper describes an optimum cutting parameters for Titanium Grade5 (Ti-6Al-4V) using Wire-cut Electrical Machining Process (WEDM). The response of Volume Material Removal Rate (MRR) and Surface Roughness (Ra)...