Experimental Investigation of Heat Transfer in Heat Exchanger Using Different Geometry of Inserts
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2016, Vol 4, Issue 7
Abstract
The investigation of heat transfer coefficient and friction factor in a single tube heat exchanger with different geometry of inserts has been presented experimentally. The experimentally obtained data for different cases is compared with the data obtained for smooth tube. The experimental analysis has been made and results were obtained for the Reynolds’s number ranging from 3000 to 18000.
Authors and Affiliations
K. A. Goudiya, V. S. Kamde, B. N. Kale
Keywords
Related Articles
- EP ID EP22377
- DOI -
- Views 175
- Downloads 3
Green computing interchange Switching function
This research is about a method for enabling user of a computing system to measure and compare the green efficiency of a set of resources used for computing task. With the use of these information, the user can select a...
Li-Fi Based A New Home Automation System
This paper presents a design and system implementation of new home automation system that uses Li-Fi technology as a network infrastructure. The proposed system consists of two main components; the first part is the web...
Fault Detection and Soft Errors Correcting Codes Using Parallel FFT
The increasing demand of low complexity and error tolerant design in signal processing systems is a reliability issue at ground level. Complex circuit is consistently affected by soft errors in modern electronic circuit...
A Novel Islanding Detection Method Based On Rate of Change of Reactive Power
Micro-grids usage among consumers has become a new attraction due their several of advantage. Its major function is to ensure the stable operation during the fault and a variety of utility grid disruption. Since the uti...
An Experimental Analysis and Comparison of the Mechanical Efficiency of Two Different Design Three Blade Wind Turbine NACA 4415 and NACA 5520 with Varying Camber Area, Camber Position and Blade Thickness
In the present era, the world is struggling for energy so lots of researches are being conducted to meet the demand. The wind energy is a renewable source of energy and it is clean and pollution free too. So it is neces...