Experimental Research Using of MQL in Metal Cutting
Journal Title: Tribology in Industry - Year 2013, Vol 35, Issue 4
Abstract
In this paper an effect of using of minimal quantity lubrication (MQL) technique in turning operations is presented. Experimental research was performed on carbon steel C45E. Technological parameters: depth of cut, feed rate and cutting speed were adjusted to semi-machining and roughing. Higher values of feed and cutting speed were used, than recommended from literature and different types of cooling and lubrication conditions in turning were applied. As a conventional procedure and technology, lubrication with flooding was applied. As special lubrication technique the MQL was used. During research, monitoring of the cutting force, chip shape, tool wear and surface roughness was performed. Relations between parameters, material machinability and economy of process were analyzed.
Authors and Affiliations
G. Globočki Lakić , B. Sredanović , D. Kramar, J. Kopač
Keywords
Related Articles
- EP ID EP141674
- DOI -
- Views 78
- Downloads 0
Airworthiness Certification of Fe-Si3N4-graphite Brake Composites for Military Aircraft
Metal matrix hybrid composites are usually preferred for high energy aircraft (1-10 MJ) brake pads (HEABP) applications. The report focuses mainly on the evaluation of the wear and braking performance of the composite fo...
Influence of Load and Sliding Speed on Friction Coefficient of IBAD Deposited TiN
The influence of applied load and sliding speed on the tribological performance, i.e. friction and wear of TiN IBAD coating in sliding with corundum ball has been evaluated using reciprocating sliding wear test. Post cha...
Tribology Database as Platform for Mobile Database and use of Mobile Technologies
In the last few years changes in information technologies, are numerous and dynam. One of those changes is the massive use of mobile devices. They have not only been used for communication, but also for access to applica...
Reciprocating Wear Behaviour of 7075Al/SiC and 6061Al/Al2O3 Composites: A study of Effect of Reinforcement, Stroke and Load
The wear behaviour comparison of Al/SiC and Al/Al2O3 composites prepared by stir casting technique is investigated to find out the effects of weight percentage of SiC/Al2O3, load and the number of strokes on a reciprocat...
Multi-Criteria Analysis of Laser Cut Surface Characteristics in CO2 Laser Cutting of Stainless Steel
In this paper an approach for multi-criteria analysis of laser cut surface characteristics using multi-criteria decision making (MCDM) approach was presented. Laser cutting experiment was conducted based on Taguchi’s L27...