Experimental Strength Analysis of Variable Stiffness Waffel-Grid Cylindrical Compartments. Part 2. Analysis Results
Journal Title: Проблеми машинобудування - Year 2019, Vol 22, Issue 2
Abstract
This paper presents the results of the experimental analysis of the stress-strain state of the variable stiffness tail compartment (section) designed by the Yuzhnoye Design Bureau. Equivalent compressive forces in the cross-sections of the tail compartment without the trans-port-erector support are analyzed. It is established that the calculated and experimental compressive forces are extremely close. Deformations in the tail compartment were measured where resistance strain gages were installed. For the measurement of displacements, displacement gauges were installed. The displacements were measured at six points. They were studied at maximum loading values corresponding to the fifth and sixth stages of loading. Axial movements are always negative, which indicates that the shell is compressed in the axial direction. The stress-strain state of the launch vehicle tail compartment was experi-mentally investigated. The circumferential normal stresses are several orders of magnitude smaller than the longitudinal ones. Therefore, the circumferential stresses were not investigated. The results of the ex-perimental studies were compared with the numerical simulation data in the NASTRAN software package. The purpose of the simulation was to confirm the workability of the tail compartment under the loads that occur during operation. In other words, the design must withstand the actual loads without destruction and the appearance of plastic deforma-tions. Special attention was paid to the zones that were directly under the brackets. The experimental results and numerical simulation data are close.
Authors and Affiliations
Maksim A. Degtyarev, Vitalii G. Danchenko, Artem V. Shapoval, Konstantin V. Avramov
Keywords
Related Articles
- EP ID EP622782
- DOI 10.15407/pmach2019.02.031
- Views 81
- Downloads 0
Solution to Non-stationary Inverse Heat Conduction Problems for Multi-layer Bodies, Based on Effective Search for the Regularization Parameter
To obtain a stable solution to the inverse heat conduction problem (IHCP), the article uses A. N. Tikhonov's method with an effective algorithm for finding the regularization parameter. The required heat flux at the boun...
Aeroelastic Behaviour of Turbine Blade Row in 3D Viscous Flow
This paper presents the results of a numerical analysis of the aeroelastic behaviour of the oscillating blade row of a turbine stage in the 3D flow of viscous gas, taking into account the non-uniform pressure distributio...
Influence of the Location of a Convector on the Distribution of the Room Temperature
This article considers the influence of various options of placing heaters in a room on energy efficiency, and creating a comfortable temperature field for people to stay in. For the research, a square room with an incli...
Calculation of Indicators of Reliability of Technical Systems by the Typical Structural Scheme Method
A method for calculating the indicators of structural reliability of systems with a large number of elements is presented. The method is based on the use of typical structural schemes, reflecting the concept of connectio...
Method for the Optimal Design of Vacuum-Evaporative Heat Pumps
A method is developed for optimally designing vacuum-evaporative heat pumps that use water (R718) as a refrigerant. This method is based on the autonomous method of the thermoeconomic optimization of thermodynamic system...