Experimental Study on High Performance Concrete by using Partial Replacement of Copper Slag and Fly Ash
Journal Title: International Journal of Trend in Scientific Research and Development - Year 2020, Vol 4, Issue 3
Abstract
The conventional concrete has lost its usage nowadays as it does not set out the present need. The term ‘High Performance’ is because of the essential usage, materials and proportions of this concrete are specifically chosen for properties such as high workability, high density and low permeability. The main objective of this study is to deal with the effects of cementitious materials in High Performance Concrete HPC for mix design of M40 grade concrete. Hence, copper slag which is the industrial by product is used as a partial replacement of fine aggregate by 0 , 15 , 30 , 45 , 60 and 75 with 20 of fly ash by the volume of cement with water cement ratio 0.36. Super plasticizer conplast SP430 is used as chemical admixture at the rate of 1.2 of cement which improves the workability. From this experimental study, so far the utilization of copper slag and fly ash observed with gradual improvement in mechanical properties such as compressive, split tensile and flexural strength in HPC. By evaluating the optimum percentage of copper slag, J. Grijasri | U. Karunya | A. Thomas Eucharist "Experimental Study on High Performance Concrete by using Partial Replacement of Copper Slag and Fly Ash" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-4 | Issue-3 , April 2020, URL: https://www.ijtsrd.com/papers/ijtsrd30460.pdf Paper Url :https://www.ijtsrd.com/engineering/structural-engineering/30460/experimental-study-on-high-performance-concrete-by-using-partial-replacement-of-copper-slag-and-fly-ash/j-grijasri
Authors and Affiliations
J. Grijasri | U. Karunya | A. Thomas Eucharist
Keywords
Related Articles
- EP ID EP686145
- DOI -
- Views 109
- Downloads 0
Feasibility Study and Entrepreneurial Success: Evidence from Selected Manufacturing Firms in Anambra State
This study assesses the extent at which manufacturing firms undertook feasibility studies prior to set up their businesses. Specifically, the study ascertain whether manufacturing firms in Anambra State ensure adequate f...
Analyzing the Works about Causes and Factors of Infertility
Infertility is the inability to become pregnant after one year of intercourse without contraception involving a male and female partner. The frequency of the female factor is 62-75 , and that of the male factor is 28-45...
Antibacterial Activity and Phytochemical Analysis of Euphorbia hirta Against Clinical Pathogens
Euphorbia hirta powdered plant material was extracted using two solvents distilled water and methanol. The water extract provide higher yield and also more antibacterial effectiveness than methanol extract used. The well...
Steel Foam Inspired from Human Bones
Historically, the concept to create synthetic cellular substances have to have been stimulated by means of herbal materials such as pumice stone, timber or bone that have all been in use for a lengthy time due to their s...
Attitude of Students towards Integral Calculus through the Screening Examination Strategy
One thing that may affect the students’ perception of mathematics is the attitude of the students towards the subject. This study was conducted to assess the attitude of students towards integral calculus. The subjects o...