Experimental Study on High Strength Concrete using Industrial Wastes
Journal Title: International Journal of Trend in Scientific Research and Development - Year 2019, Vol 3, Issue 3
Abstract
Generally the river sand is used as a fine aggregate on concrete and is obtained by mining the sand from river bed. Increased sand mining not only affects the aquifer of the river bed but also causes environmental problems. In recent days demand for river sand is increasing due to its lesser availability. Therefore the practice of replacing river sand with Metakaolin is taking a tremendous growth. It is inferred from the literature that replacement of Metakaolin upto 40 gives tremendous increase in the strength of the concrete above which the strength starts to decrease. Various literatures show that replacing with green sand 30 to 40 replacement seems to be effective. In both the cases the workability decreases with the increase in its quantity. Also Bottom ash and Metakaolin replacement results in the decrease of workability and it leads to uneconomic in the project. This paper presents the replacement of fine aggregate up to 40 . The river sand is replaced by Green sand, and Marble powder. The replacement levels of Green sand and marble powder varies from 5 , 10 , 15 and 20 . From the mix design, the w c ratio is taken to be 0.40. The specimens are to be casted, cured for the respective mix proportions and various strength characteristics of the concrete at 28 days are to be performed. The suitability of the replacement materials as fine aggregate for concrete has been assessed by comparing its strength. by Sriram R | Mr. Prabakaran | Mrs. Uma Nambi "Experimental Study on High Strength Concrete using Industrial Wastes" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-3 | Issue-3 , April 2019, URL: https://www.ijtsrd.com/papers/ijtsrd23155.pdf Paper URL: https://www.ijtsrd.com/engineering/civil-engineering/23155/experimental-study-on-high-strength-concrete-using-industrial-wastes/sriram-r
Transient Thermal Analysis for Heat Dissipation from Engine Cylinder Block with Different Shaped Holes in Fins using CFD
The cost of fuel and materials in all sectors is rising day by day. In the IC engine, the engine fails primarily because the heat transfer from the cylinder wall to the ambient air is inadequate. Heat is derived from the...
Importance of Banks in Cashless Transactions under Digitalization System
Banking sector plays an important role in economic development of India, huge changes in digitalization system and new techniques in technology have changed the entire banking system. Basically Indians are slow in nature...
Extradition within the CEMAC Sub Region Prospects and Perspectives
International co operation in criminal matters amongst states in the Central African Economic and Monetary Community CEMAC is a reality. However, this co operation is increasingly being threatened by weaknesses that frau...
Optimization of FLC Using PSO – FF Hybrid Algorithm Using DSTATCOM for Power Quality Improvement
Electrical power is the most established form of power and the people is greatly dependant on the electric power supply. A life cannot be imagined with no supply of electricity. Most of the industrial and domestic loads...
A Glimpse towards Bitcoin and its Reality Analysis on Mining and Protocol
Bitcoin has advanced as the most fruitful cryptographic currency in history. Since its launch in 2009. Bitcoin grew to comprise billions of dollars of economic value. Since then a lot of literature has been identi?ed wit...