Fabrication of LM25/SiO2 Metal Matrix Composite and Optimization of Wear Process Parameters Using Design of Experiment
Journal Title: Tribology in Industry - Year 2017, Vol 39, Issue 1
Abstract
LM25 aluminium alloy reinforced with 15 wt% SiO2 metal matrix composite was fabricated by liquid metallurgy technique. Microstructure of the fabricated composite specimen was observed using inverted metallurgical microscope and result showed uniform distribution of reinforcement particles in the matrix. The dry sliding wear behaviour of LM25/SiO2 composite was analyzed by conducting experiments using pin-on-disc tribometer. Taguchi’s method was used for designing the number of experiments and L16 orthogonal array was developed for wear analysis. Optimization of parameters like applied load (10 N, 20 N, 30 N, 40 N), sliding velocity (0.5 m/s, 1 m/s, 1.5 m/s, 2 m/s) and sliding distance (500 m, 1000 m, 1500 m, 2000 m) was done using Signal-to-Noise ratio analysis and Analysis of Variance. ‘smaller-the-better’ characteristic was chosen to analyze the dry sliding wear behaviour. Results found that load (69.17 %) had the highest impact on wear rate followed by sliding velocity (18.04 %) and sliding distance (1.5 %). The regression equation was developed and it was validated with confirmatory experiment. Scanning Electron Microscope analysis was done to observe the mechanism of the worn out composite specimen and found more delamination at the load of 40 N.
Authors and Affiliations
N. Radhika
Keywords
Related Articles
- EP ID EP228693
- DOI 10.24874/ti.2017.39.01.01
- Views 104
- Downloads 0
Cassava Leaf Nanoparticles (CLNPs) as a Potential Additive to Anti-Corrosion Coatings for Oil and Gas Pipeline
Characterization of synthesized cassava leaf nanoparticles (CLNPs) was carried out using SEM/EDX and Gwyddion software, XRD and TEM for cassava leaves (CL) ball milled at 36, 48, 60 and 72 hours. The morphological study...
Tribological Behavior of Aluminium Metal Matrix Composite with Addition of Bamboo Leaf Ash by GRA-Taguchi Method
The bamboo leaf ash (BLA) which was extruded from agro waste was used as a particulate reinforcement to produce economical AMMCs. The dry sliding wear behavior of Al-4.5 wt.% Cu alloy with the addition of 2, 4 and 6 wt.%...
Investigation of Wear Pattern in Piston Ring of an IC Engine
Piston Ring, as small as it appears, plays quite an important role in contribution to friction and wear in an IC engine. As a first approximation most wear models, have quantified wear of a piston ring in terms of total...
Development of Asbestos - Free Brake Pad Using Bagasse
Development of asbestos-free brake pad using bagasse was investigated with a view to replace the use of asbestos whose dust is carcinogenic. The bagasse were sieve into sieve grades of 100, 150, 250, 350 and 710μm. the s...
Ejection Performance of Coated Core Pins Intended for Application on High Pressure Die Casting Tools for Aluminium Alloys Processing
In high pressure die casting (HPDC) process of aluminium alloys cast alloy soldering severely damages tool surfaces. It hampers casting ejection, reduces the casting quality and decreases the overall production efficienc...