Finite Element Simulation for Cutting of Ti6AI4V
Journal Title: International Journal of Science and Research (IJSR) - Year 2015, Vol 4, Issue 3
Abstract
Abstract: Titanium Ti6AI4V alloy is considered difficult to machine especially at higher cutting speeds, because of inherent properties such as low thermal conductivity, high chemical reactivity with cutting tool materials at elevated temperature, this leads to shorten the tool life and poor quality of the surface finishing of the workpiece being machined. By the use of Finite Element (FE) simulations have reduced the burden of extensive experimental trials in understanding the deformation behavior and optimize the cutting process. In this paper the finite element analysis (FEA) of machining for Ti6AI4V is presented. In this particular case the FEA is applied for both workpiece material and cutting tool material. Then at the end of this paper will be able to model and simulate, thereafter to study the influence of Cutting forces, cutting temperature and tool wear.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP357923
- DOI -
- Views 74
- Downloads 0
Clinico-Pathological Study of Non-Neoplastic Lesions of Uterine Cervix with their Histopathological Categorization
The non-neoplastic lesions of the uterine cervix are frequently seen in the histopathology departments. Of the 821 cervical specimens received, 909 non-neoplastic lesions were evaluated. Most of the patients’ presented w...
Impact of Organophosphate (Chloropyriphose) on Weight and Growth of Earthworm, Eisenia foetida
Chloropyriphose is an organophosphate pesticide which is highly affected on earthworm’s life or population of earthworm. The objective of this work was to measure the impact of pesticide on earthworm, Eisenia foetida. Fo...
Performance Analysis of Three Phase T source Inverter
This paper investigates the performance analysis of T-source Inverter with simple boost control technique for boosting the voltage. T-source impedance network is newly invented to overcome the drawbacks of Z-source inver...
Identification and Location of Faults in Three Phase Underground Power Cables by using Mexican Hat and Coif Let Wavelet Transform
" Abstract: Estimation and d termination of fault in an underground cable is very important inorder to clear the fault quickly and to restore the supply with minimum interruption. This paper presents determination and lo...
Agriculture Decision Support System As Android Application
"This is android application which will be useful for farmers & agricultural institutes for cultivation of various kind of crops in various type of atmosphere . Android mobile use in Agriculture is as the core componen...