Forced Convection upon Heat Sink of AL-Cu for Design Optimization by Experimental and CFD Analysis for Cooling in CPU
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 2
Abstract
A heat sink device, for use with specific power input at 100V and 20W to the heater, attached at the base plate of copper, and then obtained the average temperature of Heat sink with the help of 12 thermocouples. Two specimens of heat sinks were designed and were tested for mass flow rate and heat transfer coefficient with base of 1mm&2mm&tip dimensions varying as 0.5mm, 1.00mm, respectively. By experimenting and CFD simulations, optimization of heat sink design was done. Then, correlation and validation were to be adopted.
Authors and Affiliations
Srinivas D, Ramamurthy S, Juhi A
Keywords
Related Articles
- EP ID EP585869
- DOI 10.24247/ijmperdapr201984
- Views 74
- Downloads 0
Design and Modeling Studies of Tube End Expansion using Response Surface Methodology
The production of various profiles on the ends of the tubes is referred as tube end forming process. In the present work, the elevated temperature forming studies have been performed. The thin walled tubes have been subj...
Design of a Quadruped Robot and its Inverse Kinematics
Mobile robots have many abilities, of which the most unique one is the mobility. The terrain over which, these robots must be able to move is often uneven, slippery or muddy, which gives rise to many challenges, particul...
COMPARATIVE ANALYSIS OF DISPERSION COMPENSATION USING ELECTRONIC DISPERSION COMPENSATION TECHNIQUES AT DIFFERENT BIT RATES USING SINGLE MODE FIBER
The performance in the fiber optical communication is majorly limited by a phenomenon called dispersion which generally starts growing after 2Gbps data rate. The pulse gets widened as they travel down the fiber. This wid...
A Customized Wavelet-Based Hierarchical A Posteriori Error Indicator for Linear and Nonlinear PDES
This paper presents an adaptive method that can be used to improve the finite element solution of a linear or non-linear PDE by indicating the local as well as global errors. This wavelet-based adaptation is based on hie...
Optimization of the Process Parameter in Drilling of GFRP using HSS Drill
Fabrication and assembly of parts requires drill holes. The importance of better productivity of the Air craft parts while assembling of polymer composite to avoid the rejection process in drilling operation. The drillin...