FRICTIONAL PROBLEMS IN CONTINUOUSLY VARIABLE TRANSMISSION BELT DRIVES
Journal Title: Tribologia - Year 2017, Vol 275, Issue 5
Abstract
The article describes the results of the research carried out on the evaluation of the influence of friction pairs (rubber belt – belt pulley in belt drive) on the ability to transmit power. In order to determine the characteristics of the belt drive operation, measurements were made on a real belt drive from the drive train of a light two-wheeled vehicle. The measurement was carried out in conditions of changes in the dynamic load. The measurements of the belt slip on the belt pulley within the whole range of the changes of gear ratios and angular speed of the engine were made. During the tests, belts made from various rubber mixtures were compared. The values of the friction coefficients between the surface of belts and the belt pulley were measured. Model analyses of the impact of belt slip on the wheel related to the temperature of Belt drive elements were also made. Generally, one can ascertain that, in belt drive systems, power losses are a combination of speed losses and torque losses. The increase in the efficiency of belt drives is possible by decreasing power losses. It is possible to obtain the high performance of continuously variable transmission belt drives with a V- belt solely with the proper choice of the design parameters, which is possible only after the exact recognition of the operational characteristics unique to this class of belt drive systems.
Authors and Affiliations
Wojciech SZCZYPIŃSKI-SALA, Krzysztof DOBAJ, Adam KOT
Keywords
Related Articles
- EP ID EP237060
- DOI 10.5604/01.3001.0010.5923
- Views 80
- Downloads 0
Przebieg procesu zacierania smarowanych wysokoobciążonych skojarzeń ciernych z elementami pokrytymi powłoką WC/C
Celem pracy było opisanie mechanizmów niszczenia smarowanego wysokoobciążonego węzła tarcia z elementami pokrytymi niskotarciową powłoką WC/C tworzących strefę tarcia. Badania wykonano dla niskotarciowej powłoki WC/C (a-...
METODA OCENY TRWAŁOŚCI POWŁOK MALARSKICH PODDANYCH ODDZIAŁYWANIU MASY MINERALNEJ
W pracy omówiono problemy dotyczące usterek pasywnych powłok malarskich. Zidentyfikowano 4 przyczyny ich powstawania: konstrukcyjne, technologiczne, eksploatacyjne i zużyciowe. Omówiono znormalizowane metody oceny jakośc...
MODIFYING THE LUBRICATING PROPERTIES OF OILS USED IN JET ENGINES AND FLIGHT CONTROL SYSTEMS
The article presents the problems of lubrication and types of lubricants used in jet engines. The results of tribological properties were presented: weld point Pz, load-wear index Ih, last nonseizure load Pn, seizure loa...
THE INFLUENCE OF PROLONGED KNEADING IN THE PRESENCE OF WATER ON THE TRIBOLOGICAL CHARACTERISTICS OF GREASES CONTAINING ORGANIC AND MINERAL ADDITIVES
This paper presents the tribological characteristics of synthetic greases containing mineral and organic additives after prolonged kneading in the presence of water. The investigated greases were composed on a base of pa...
Wpływ warunków eksploatacji na własności cieplne bezstykowego uszczelnienia czołowego
W pracy przedstawiono wyniki badań symulacyjnych dotyczących wpływu parametrów eksploatacyjnych na rozkłady temperatury w elementach konstrukcyjnych oraz w warstwie medium rozdzielającej pierścienie. Sformułowany model m...