Gas Dynamical Capillary Flowmeters of Small and Micro Flowrates of Gases
Journal Title: Energy Engineering and Control Systems - Year 2015, Vol 1, Issue 2
Abstract
The possibility of application of glass capillary tubes (CTs) as sensors of small and micro flowrates of gases was justified. The accuracy of a number of CTs flowrate equations was analyzed on the basis of experimental studies of CTs flowrate characteristics. It was shown that CTs can be applied as primary devices of small and micro flowrates of gases without individual calibration. The results of studies on the dynamic properties of gas dynamical capillary flowmeters of small and micro flowrates of gases constructed on the basis of glass CTs in the branches of a measuring bridge diagram are presented. The effects of various factors on the dynamic properties of the gas dynamical capillary flowrate transducers (GDCFTs) were analyzed. Recommendations on construction of the inter-capillary pneumatic measuring chambers (PMCs) of GDCFTs to provide the needed dynamic properties of the flowmeters are presented. The technique for defining the needed ratio of PMCs volumes in a GDCFT to provide the needed dynamic properties of the flowmeters on the stage of their design and construction is described.
Authors and Affiliations
Ivan Stasiuk
Keywords
Related Articles
- EP ID EP255559
- DOI 10.23939/jeecs2015.02.117
- Views 104
- Downloads 0
Methodology for Improving Mathematical Model of Ultrasonic Flowmeter to Study Its Error at Distorted Flow Structure
The paper presents a methodology for improving mathematical model of ultrasonic flowmeter (USM) results through the application of CFD simulation along with experimental reference data on measured consumption. On the bas...
Investigations on the Innovation Model of Exergy Effectiveness of Air Conditioning System for Operating Cleanrooms
The issue of fuel and energy saving is a top priority for energy technological systems (ETS) such as air conditioning systems (ACS). Thus, reduction of energy consumption for ACS requires optimization of these systems wh...
Influence of Parameters of Induction Motor-Centrifugal Pump Units with Hydropaths Connected in Series on their Modes
Using the mathematical model of the pump station power supply system in steady-state modes developed by the author, the influence of the parameters of induction motor-centrifugal pump units with in-series-connected hydro...
High-Speed Computer Simulation of Electrical Circuits
The well-known numerical-analytic method based on zeroes/poles matching (as z-transform realization) of equivalent transfer function or complex impedance (conductivity) in Laplace domain was proposed for high-speed compu...
Dynamic Modelling of Centrifugal Hydraulic Load of Pumping Station Electric Drive
The paper analyzes modern trends in modelling the centrifugal hydraulic load of the pumping station electric drive. It was found that a very simplified approach to the representation of one of the inextricably linked sub...