Health Monitoring System Using Wireless Sensor Network
Journal Title: International Journal of engineering Research and Applications - Year 2018, Vol 8, Issue 1
Abstract
This paper proposes an efficient approach to monitor the illness of the patient during the check up condition. Now a days medical equipments help the patient monitoring; also avoid lot of risk by Doctor‟s in ICU. These medical sensors are tattered on the wrist and finger to monitor the patient‟s condition. These medical sensors will sense the condition of patient‟s body and collect the data from patient body and send a message via Global System Mobile device to concern person or doctors. These data is communicated via ZeeBee wireless device. The sensors used are ECG (ad8232) sensor and blood pressure sensor. Signals are obtained and are displayed using Arduino Uno board. Body blood pressure is displayed on serial plot and ECG signal is monitored on PC through MATLAB, if the irregularities in the measured variables are noticed, a message alert will be sent to the medical staff.
Authors and Affiliations
Sharanbasappa Sali, Dr. Parvathi C. S.
Keywords
Related Articles
- EP ID EP393444
- DOI 10.9790/9622-0801040412.
- Views 97
- Downloads 0
Analysis Effect of Sedimentation at MHP Type Turbine Open Flume on Irrigation Channel
The MHP utilization in irrigation canals wear Plopeler Open Flume turbine type. PLTMH of this type, in the rainy season affects the quality of the electrical power produced, such as the generator voltage V (Volt), turbin...
Optimization of Thermal Performance on Evacuated Tube Solar Collector Water Heating System
Solar energy is considered one of the main alternative sources of energy to replace the dependency on other fossil resources. Solar water heating are very common systems, extensively used in many countries with high sola...
Reliabilitystudy of Solar PV Power Production In Terms Of Weather Parameters Using Monte Carlo Simulation
In this study the comprehensive reliability in terms of clearness index for power production of HIT, amorphous silicon & multi-crystalline silicon (m-cSi) technologies has been analyzed. The energy estimation of these th...
Minimum Mismatch of Current in Fully Differential Charge Pump for Integer N- DPLL
Fully Differential ended charge pump (FDCP) are proven to have advantages over single ended charge pump at the cost of complexity and required more power for implementation for digital phase locked loop(DPLL). Wide swing...
Parametric Investigation of Plane Frame Structure Using Excel Vba And Sap2000 oapi Based Programming
In this paper, effects of a critical structural parameter, beam-to-column stiffness ratio (on seismic lateral force distribution and its corresponding displacement (s) on frame members were observed. For this purpose,...