Heat Source Effects in Heat and Mass Transfer Of Nano Fluid Flow past a Sheet
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2014, Vol 4, Issue 1
Abstract
The Heat source/sink and suction/injection effects are studied during the Heat and Mass transfer through copper, water nano-fluid along an inclined permeable oscillating flat sheet. The governing equations are solved and the influence of various parameters is analyzed. The Rate of heat transfer for volume fraction against heat source is also analyzed.
Authors and Affiliations
G. V. Srikanth
Keywords
Related Articles
- EP ID EP126132
- DOI -
- Views 114
- Downloads 0
DSTATCOM with LCL Filter to Improve Voltage Sags and Current Harmonics in Power Distribution System
An increasing demand for high quality, reliable electrical power and increasing number of distorting loads may leads to an increased awareness of power quality both by customers and utilities. The most common power quali...
tudy of Floating Body Effect in SOI Technology
The paper presents the floating body effects of PD/FD of SOI technology and also discusses the issues behind the effects, gives the clear description of factors effecting floating body such as threshold voltage, dr...
Design of Shaft Is an Important Tool in Mercerization Machine
Mercerizing is one of part of wet processing technology. It is the special type of treatment.Mercerization is done to get some special properties of the textile materials. In this process, the physical properties of the...
Investigate the Route of Chaos Induced Instabilities in Power System Network
In this paper possible causes of various instability and chances of system break down in a power system network are investigated based on theory of nonlinear dynamics applied to a Power system network. Here a sim...
Solidification Simulation of Aluminum Alloy Casting – A Theoretical and Experimental Approach
Aluminium alloy castings are extensively used in general engineering, automotive and aerospace industries due to their excellent castability, machinability and high strength-to-weight ratio. The major problem w...