High-cycle notch sensitivity of alloy steel ASTM A743 CA6NM used in hydrogenator turbine components
Journal Title: Frattura ed Integrità Strutturale - Year 2010, Vol 4, Issue 14
Abstract
The presence of notches and other stress concentrations in turbine blades and other notch hydraulic components is a current problem in engineering. It causes a reduction of endurance limit of material. In that sense, specimens of the ASTM A743 CA6NM alloy steel using in several hydrogenator turbine components was tested. The specimens were tested under uniaxial fatigue loading with a load ratio equal to -1, and the considered stress concentration factors, Kt, values, calculated with respect to net area, were 1.55, 2.04 and 2.42. In order to determine the fatigue limit for such notch type, a reduction data method by Dixon and Mood, Staircase method was used. This approach is based on the assumed target distribution of the fatigue limit. For such geometry at least 8 specimens were tested. In addition, the Peterson and Neuber’s notch fatigue factor were compared through fatigue notch reduction factor, Kf, obtained from experimental data. According to results obtained it was possible to conclude that the tested material is less sensitive to notches than the prediction of the Peterson and Neuber’s empirical models.
Authors and Affiliations
B. L. da Silva, J. L. de ALmeida Ferreira, J. A. Araùjo
Keywords
Related Articles
- EP ID EP119289
- DOI 10.3221/IGF-ESIS.14.04
- Views 44
- Downloads 0
Mechanical behaviour of wood T-joints. Experimental and numerical investigation
Results of a double-shear single-dowel wood connection tested under monotonic quasi-static compression loading are presented and discussed in this paper. The wood used in this study was a pine wood, namely the Pi...
Analysis of the causes of failure in 5Cr-1Mo pipes mounted in a preheating furnace
The oxidation resistance of iron-based alloys depends on the formation of thin protective films consisting of reaction products between the alloys and the ambient atmosphere. The high corrosion resistance of Fe-Cr-...
Development of a formalism of movable cellular automaton method for numerical modeling of fracture of heterogeneous elastic-plastic materials
A general approach to realization of models of elasticity, plasticity and fracture of heterogeneous materials within the framework of particle-based numerical methods is proposed in the paper. It is based on building man...
Crack initiation at V-notch tip subjected to in-plane mixed mode loading: An application of the fictitious notch rounding concept
The fictitious notch rounding concept is applied for the first time to V-notches with root hole subjected to in-plane mixed mode loading. Out-of-bisector crack propagation is taken into account. The fictitious no...
A micromechanical approach for the micropolarmodeling of heterogeneous periodic media
Computational homogenization is adopted to assess the homogenized two-dimensional response ofperiodic composite materials where the typical microstructural dimension is not negligible with respect to thestructural...