IDENTIFICATION AND QUANTIFICATIONS OF CHEMICAL ELEMENTS AND MICROSCOPIC CHARACTERISATION OF THE COPPER BASE ALLOY AT DIFFERENT TEMPERATURE OF MOULDS
Journal Title: TEHNOMUS - Year 2011, Vol 18, Issue 1
Abstract
In this research paper, the structure identified by microscopic analysis for one copper base alloy at two different moulds are comparing between them because the solidified conditions was different. The samples were prepared by induction furnace using electrolytic copper and zirconium sponge and the ingots were cast into the steel moulds where solidifies its. Copper alloys are an knew group of casting Cu alloys, well-known as corrosion resistant materials, which are widely used as the devices for their antibacterial properties. Depending on the combination of alloying elements and other factors, like solidification temperature or micro alloying elements, the alloys with different mechanical and physic-chemical properties are obtained.
Authors and Affiliations
Cristina CAMBER IORDACHE, Maria VLAD, Simion BALINT, Vasile BASLIU, Mihaela GHEORGHE
Keywords
Related Articles
- EP ID EP92102
- DOI -
- Views 125
- Downloads 0
RESEARCH ON STRESS AND DEFORMATION STATE IN PLASTICAL BENDING WITH STRETCHING
The paper presents a theoretical solution of the stress and deformation state in plastically bending with stretching. It was established calculus relations of the neutral layer relative displacement coefficient, bending...
MONTE CARLO PIVOTAL CONFIDENCE BOUNDS FOR WEIBULL ANALYSIS, WITH IMPLEMENTATIONS IN R
To gain expert insight in the inner workings and pitfalls ofcommercial lifetime analysis software, the authors created an open source alternative with asubset of analysis tools and made it freely available as a package f...
ASPECTS REGARDING THE QUALITY OF CAST IRON PRODUCED IN S.C.FONTUR S.A. SUCEAVA
The authors analyze the quality of produced cast iron and molded forms from SC FONTUR SA Suceava. For this purpose samples were cast from different batches of samples, from which were made tensile specimens, samples for...
MANGEMENT OF TECHNICAL DATA IN THE STUDY OF THE BRAKING SYSTEM OF CARS
Braking process of a vehicle is complex, giving possibility to the driver to reduce car’s speed or to stop it at big speed in a short distance. Using the diagrams registered for the different working conditions, defined...
EXPERIMENTAL RESEARCH ABOUT INFLUENCE OF INCLINATION ANGLE DIRECTION UPON THE SURFACE ROUGHNESS IN BALL END MILLING OF OLC45 (C45) MATERIAL
Machining with ball end mills become a very usefull process to obtain pieces with complex surfaces. Possibilities of machining with ball nose end mills represent a adequate process to achieve surfaces with a good quality...