Identification of distribution features of the instantaneous power components of the electric energy of the circuit with polyharmonic current
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 2, Issue 8
Abstract
Many researchers pay attention to the problem of the distortion electric power. The known theoretical results that are reflected in the acting standards are reasonably criticized in the part of the distortion power generation by current and voltage of different frequencies. The paper deals with the approach based on the order of generation of instantaneous electric power components depending on the combination (sum or difference) of current and voltage frequencies. The analytical expressions for the instantaneous electric power components of a harmonic current circuit consisting of a capacitor, an inductance coil and a resistor connected in series are obtained. With this purpose in view, two components – active and reactive – are singled out from the obtained four components of instantaneous power, as well as the orthogonal power components oscillating with double frequency. It is demonstrated that the sum of the squares of the active and reactive components and the sum of the squares of the mentioned orthogonal components coincide and are equal to the total (apparent) power. The used method is developed for the general case of polyharmonic current and voltage. In this case, it is observed that the active and reactive power components can be singled out from the instantaneous power components as orthogonal quadrature components of zero frequency. Though, it is impossible to single out the apparent power. Two numerical experiments with periodic current and voltage, containing three harmonics each, were carried out. The acting values of currents and voltages in each of the experiments were assumed equal. In this case, the amplitudes of the second and the third harmonics exchanged their positions. This example demonstrates that the integral indices of the apparent power and the distortion power, calculated by conventional methods, proved to be the same in both cases, which is incorrect. Under the same conditions, such instantaneous power components whose values turned out to be different for each of the experiments are found among the proposed instantaneous power components. As a result, it is proposed to use a root-mean-square value of the mentioned components for the assessment of the distortion degree in relation to the root-mean-square value of the instantaneous power
Authors and Affiliations
Mohamed Zaidan Qawaqzeh, Olexii Bialobrzheskyi, Mykhaylo Zagirnyak
Keywords
Related Articles
- EP ID EP666332
- DOI 10.15587/1729-4061.2019.160513
- Views 78
- Downloads 0
Improvement of the inverse dynamics method for high-precision control of nonlinear objects under conditions of uncertainty
Synthesis of automatic control systems (ACS) of nonlinear objects is a well-known scientific problem. The method of inverse dynamics makes it possible to synthesize high-precision ACSs of nonlinear objects. However, unde...
Development of methods for estimating the environmental risk of degradation of the surface water state
<p>We presented three new methods for assessment of the environmental risk of deterioration of a surface water state. We defined the ecological risk of deterioration of surface water at the state level as an addition of...
Development of the formulation and quality assessment of immunostimulating fresh-mixes with a balanced potassium-protein composition
<p>Using the methods of mathematical modeling, we developed formulations for the immunostimulating fresh-mixes. We determined the percentage of plant raw materials, which corresponds to maximum potassium content in the f...
Influence of elastic characteristics of raw cotton on the mechanics of feed rollers in the cleaners from small impurities
<p>The effect of the elastic characteristics of raw cotton on the mechanics of the feed rollers in fine impurity cleaners depends on maturity. In cleaners from small impurities, mechanisms are used with spike rollers hav...
Improving efficiency of machining the geometrically complex shaped surfaces by milling with a fixed shift of the cutting edge
<p>In order to improve efficiency of machining by milling geometrically complex shaped surfaces, mainly the methods related to improvement of properties of the tool material, change of composition and properties of the t...