IMPROVED THE ADAPTATION FOR THREE PHASE ACTIVE FILTER UNDER NON-IDEAL-LOAD USING SAMPLE CURRENT CONTROL
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 3
Abstract
In this paper, a comparison between sample current control and direct current control to show the efficiency of the two current control method of Active Power Filter. The main function of the scheme was a duty by the two-level three phases inverter. According to the classic approach, transistors are converted depending on the sign of the current error, in turn, sampled at equal intervals. Both methods follow the synchronous toggle principle. In the first method, the current vector at the end of the interval is predicted for two possible cases when the operating voltage vector towards the current fault or zero voltage vector is applied. An error generates a smaller current error at the end of the selected sampling period, thus reducing the switching frequency. In the second method, the most appropriate operating voltage vector will succeed in zero vectors over the same period. A simple algorithm is used to calculate the duty cycle to achieve the smallest possible error. Both methods are simulated with three different load modes: no load, RL load, and nonlinear load. At the end of the article, the behavior of the second method, SCC, is worth more. The simulation results demonstrate the viability and effectiveness of the two technique of current control in reducing the ripple, losses, and Total Harmonic Distortion of supply current.
Authors and Affiliations
Huynh Le Minh Thien, Nguyen Xuan Tien, Tran Thanh Vu, Ho Van Cuu
Keywords
Related Articles
- EP ID EP572229
- DOI 10.26480/jmerd.03.2019.76.80
- Views 68
- Downloads 0
MICROSTRUCTURES AND ELEMENTS DISTRIBUTION IN THE TRANSITION ZONE OF CARBON STEEL AND STAINLESS STEEL WELDS
The change of microstructures and elements distribution around the carbon fusion line in carbon steel and stainless steel welds were investigated by means of optical microcopy (OM), scanning electron microscopy (SEM) and...
THE FAULT LOCATING SYSTEM OF THE HIGH-SPEED MAGLEV TRAIN
Analyzing and researching the levitation and guidance sensor fault location system of high-speed maglev train, we developed an offline testing method of sensor fault location system, which can carry on the fast positioni...
CROSS-POLAR ROUTES AS A FACTOR THAT CHANGED THE GEOMETRIC LAYOUT OF LONG-HAUL AIRCRAFTS FLYING OVER LONG DISTANCES
A structural-parametric analysis of the effect of infrastructure constraints in the basing of long-haul aircrafts on the choice of the aerodynamic balancing scheme of the aircraft was carried out. As a criterion, the car...
COMPUTER WITH CHANGEABLE ARCHITECTURE
The relevance of this article is that, despite the rapid development of computer technologies, it has not been yet invented the architecture that did not have vulnerabilities for hacker attacks. The purpose of the paper...
FORMATION OF SPATIAL THINKING OF FUTURE ENGINEERS ON THE BASIS OF FUNDAMENTAL GRAPHICS TRAINING
The level of graphics training in an engineering higher school is the most important characteristic of the skill of the graduate. The period of formation of professional readiness of a specialist is closely connected wit...