Improving Properties of Concrete by Adding Pozzolonic Material Such as, Silica Fumes and Ground Glass Blast Furnace Slag in India

Abstract

The aim of the study was to evaluate the performance of high performance concrete (HPC) containing supplementary cementitious materials in both binary and ternary systems. Concretes were prepared to have a slump value between 60-90 mm at a constant water binder ratio of 0.30.Thetest variables included the type and the amount supplementary cementitious materials (SCMs) such as Silica fume, class F fly ash (FA) and Ground granulated blast furnace slag (GGBS). Portland cement was replaced with fly ash up to 40%, silica fume up to 15% and GGBS up to a level of 70%. The physical properties were assessed from compressive strength and transport properties (air permeability and sorptivity), whilst the durability characteristics were investigated in terms of carbonation, chloride migration, chloride diffusion, electrical resistivity and salt scaling resistance. The hydration properties of cement pastes containing SCMs have been investigated in order to understand the behavior of HPC. For Hydration properties, cement pastes were prepared in two series (A and B). Mixes of series A had a fixed water binder ratio of 0.30 with super plasticizer, whereas the water binder ratios of series B were equivalent to the standard consistencies. The results confirmed that silica fume performed better than other SCMs for strength development and bulk resistivity. In terms of resistivity of concrete, the best performance was obtained for 15% SF concrete. When 7.5% SF was used in 40% FA and 50% GGBS concrete, the resistivity was less 15% SF concrete. The ternary mixes containing GGBS/FA and SF performed best amongst all mixes to resist chloride diffusion. The mix containing fly ash showed favourable permeation results. All ternary combinations can be considered to have resulted in high performance concretes with excellent durable properties. The maximum carbonation depth observed for concrete containing 40% FA and 7.5% SF was about 5 mm, which is less than the cover of reinforced steel bars to cause corrosion. The non steady state [2] migration coefficients of concretes containing different types of SCMs were significantly lower than the controlled concretes. The coefficient was minimum for concrete containing 15% SF. The scaled mass for 40% FA concrete was the maximum among all mixes. For concrete containing was maximum among all the mixes. For concretes containing GGBS, there was no significant change in scaled mass, when compared to control concretes. However, the use of 15% SF was found to reduce the scaled mass. The use of 7.5 % SF in 40% FA and 50% GGBS concrete was found to reduce the scaled mass. The x-ray diffraction data showed that with the addition of high volume FA, GGBS and SF the peak intensity of Ca(OH)2 was retarded and quartz peaks appeared in the paste containing FA denoting a certain amount of crystalline silica in FA. This was more pronounced at later age. The combination of 40% FA and 7.5% SF showed the highest consumption of Ca(OH)2. Thermo gravi-metry data confirms the addition of SCMs in cement resulted in the formation of decreased amount of Ca(OH)2 in the hydration products considerably at later age when compared to early age. Although the addition of high volumes of SCMs decreased the compressive strength of cement pastes at early age, the use of 15% SF improved the strength. However from the cost point of view, it is suggested that a combination of 40% FA and 7.5% SF or 50% GGBS and 7.5% SF can be beneficially used to improve the hydration properties and compressive strength of cement pastes. Mohd Ismail Wani | Mr. Zeeshan Khan"Improving Properties of Concrete by Adding Pozzolonic Material Such as, Silica Fumes and Ground Glass Blast Furnace Slag in India" Published in International Journal of Trend in Scientific Research and Development (ijtsrd), ISSN: 2456-6470, Volume-1 | Issue-5 , August 2017, URL: http://www.ijtsrd.com/papers/ijtsrd2338.pdf http://www.ijtsrd.com/engineering/civil-engineering/2338/improving-properties-of-concrete-by-adding-pozzolonic-material-such-as-silica-fumes-and-ground-glass-blast-furnace-slag-in-india/mohd-ismail-wani

Authors and Affiliations

Keywords

Related Articles

The Negative Impact of the Birtual Threats to the Political Stability of the Society

In the following article the definitions of the virtual world, virtual world and virtual threat, the negative impact of the virtual threats to the stability of the society are analyzed from the scientific theoretical vie...

A Study of Community Entrepreneurship Development Research A Resource of Clarification and Forecast

Community entrepreneurship, as training and a field for academic research, gives an exceptional chance to test, question, and reevaluate ideas and suppositions from various fields of the executives and business look into...

Advanced Virtual Assistant Based on Speech Processing Oriented Technology on Edge Concept S.P.O.T

With the advancement of technology, the need for a virtual assistant is increasing tremendously. The development of virtual assistants is booming on all platforms. Cortana, Siri are some of the best examples for virtual...

A Universal Printed Antenna for UHF RFID Applications

In this paper, a printed rectangular monopole antenna is designed for RFID (Radio Frequency Identification) reader applications. The antenna is designed to operate at a frequency of 860 MHz to 960 MHz allocated for UHF R...

Determinants of Business Performance in the Nigerian Manufacturing Sector

This study examines the determinants of business performance in the Nigerias manufacturing sector. The study was necessitated by the perceived declining performance of the Nigeria manufacturing sector. Secondary data cov...

Download PDF file
  • EP ID EP358077
  • DOI -
  • Views 109
  • Downloads 0

How To Cite

(2017). Improving Properties of Concrete by Adding Pozzolonic Material Such as, Silica Fumes and Ground Glass Blast Furnace Slag in India. International Journal of Trend in Scientific Research and Development, 1(5), -. https://europub.co.uk/articles/-A-358077