Increasing the noise immunity of signal processing units of telecommunications on the basis of the modified synchronization schemes
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2015, Vol 0, Issue 61
Abstract
The paper presents mathematical models formalizing analytical description of the synthesis filters polyphasic device synchronization signal processing blocks of telecommunications. A device synchronization of telecommunications using polyphasic and polyphase filters. The peculiarity of these schemes is that they contain only three multiplications. It was determined that the fractional change speeds when interpolation and decimation factors are low enough effective filters polyphasic interpolators Farrow, who can effectively arbitrary (irrational) resampling. A simulation scheme of information transmission channel using polyphase interpolation solutions. It is shown that this approach allows for structural synthesis device clock synchronization, enhance immunity signal processing blocks and get the advantage of the modified scheme for a given level of probability of bit errors. Experimentally, the use of cubic Lagrange interpolators in the circuit block synchronization signal processing with 16QAM (experimental conditions) allows you to gain at 1.4 dB for BER = 10-4, modified interpolation scheme and agreed multiphase filtering scheme allow you to gain at 3 dB for BER = 10-4 and modified interpolation device at 3.4 dB Performance interpolation device primarily for high values .
Authors and Affiliations
J. Boiko
Research of the potential characteristics of a radar signal with linear frequency modulation in the area of low correlation
The composite radar signal with linear frequency modulation is reviewed. The results of calculations of potential descriptions of signal are resulted for correlation functions are got and contours in the area of low corr...
UHF six-channel radiometer
Reviewed the results of designing of six-channel radiometer and its main technical parameters.
Non-reciprocal passive devices closely spaced ferrite inserts internal magnetic field investigation
Determining demagnetizing factor method of two ferromagnetic disks is described. Dependence of two ferrite disks demagnetizing factor from distance between them is investigated by using ferrite disks of type 30SCH9 with...
Calculations of circular waveguide with a rectangular metal insert
Calculated and analyzed the basic parameters of electromagnetic wave in a circular waveguide with a rectangular metal plate in the following cases: when the circular waveguide without metal plate for a H11 wave of subcr...
Conditions of existence and classification of the feedback in electronic circuits
The article analyzes the state of matter on existence and classification of feedback in electronic circuits. It is shown that the presence of dependent sources is necessary but it is not sufficient condition for the feed...