Influence analysis of the main types of defects and dam-ages on bearing capacity in reinforced concrete elements and their research methods
Journal Title: UNKNOWN - Year 2019, Vol 22, Issue 1
Abstract
In current economic trends, changes in construction using are required. It usually leads to changes in value and type of the working load on building structures, with the requirement to rate the technical state and replace or strengthen the elements. An important aspect of determining the residual bearing capacity of damaged bending reinforced concrete elements is the research concerning the influence of difference defects and damages on the change of strength and deformability. In the article main types of damages and defects, methods of studies of damaged reinforced concrete elements and the expediency of usage of this elements are described. However, most methods are suitable only for certain defects and damages due to the large complexity of calculations and the consideration of multifactoriality. Significant complexity of a single method for calculating damaged elements depends on the possible changing stress strain state of an element in combination with certain defects and damages, the presence of a non-complete separation where during loading or alteration of the damaged element the fractions become included in the work, reinforced concrete is the composite material which carrying complexity in calculating the joint work of its components.<br/><br/>
Authors and Affiliations
Мaksym Lobodanov, Pavlo Vegera, Zinoviy Blikharskyy
Keywords
Related Articles
- EP ID EP599525
- DOI 10.30657/pea.2019.22.05
- Views 62
- Downloads 0
Supporting autonomous vehicles by creating HD maps
Maps are constantly developing, also, the newly defined High Definition (HD) maps increase the map content remarkably. They are based on three-dimensional survey, like laser scanning, and then stored in a fully new struc...
Comparison of low and high frequency fatigue tests
The paper presents the results of low and high frequency fatigue tests carried out on nodular cast iron. The specimens of synthetic nodular cast irons from three different melts were studied in the high cycle fatigue reg...
Selected aspects of hydraulic issues in heating systems
Rational and efficient use of thermal energy in recent years has resulted in significant changes in the heating system as well as technological progress. In order to design a heating system properly and exploit it correc...
Effect of tribological conditions for properties thermal spraying
The present contribution deals with the influence of tribological conditions on coating quality. Two types of coatings were selected for analysis WC-WB-CO and WC-FeCrAl, to advise that a new type of coating - carbide gre...
A STUDY ON THE UTILIZATION OF LEAN TECHNIQUES/TOOLS IN INDIAN SMES
The Small and Medium Enterprises (SMEs) are the backbone of all the major economies around the world. Majority of these industries are facing tough environment for existence. The present study explored the most common an...