Influence of production method on selected properties of VT 22 titanium alloy
Journal Title: Archives of Materials Science and Engineering - Year 2017, Vol 1, Issue 87
Abstract
Purpose: The paper presents the results of phycisochemical and mechanical properites of titanium alloy VT 22. Samples - input material and after injection casting were carried out. Design/methodology/approach: The samples were made of VT 22 titanium alloy. The aim of the study was a comparison of corrosion resistance and surface geometry of input material and material produced by injection method. The corrosion resistance test by using 3 electrode method were carried out. Surface geometry by profilometer were conducted. Moreover the microhardness tests were carried out by using Vicker’s metohod. As well as microstructure observation by using light microsope were carried out. The studies were carried out on 2 samples – one sample from input material and sample after injection method. There 10 samples were produced during studies. Findings: Research has shown that the use of injection casting method affects on surface geometry and corrosion resistance of produced samples. It has been observed that samples produced by using injection casting in comparison to input material have lower corrosion rate as well as higher microhardness of surface. Roughness profile is incomparable because the input material on its surface was undulating. But roughness affects on corrosion resistance. Moreover there differences between structures were observed. Research limitations/implications: During the comparison of roughness profile there were problem because input material was undulating. Practical implications: Injection method can be used as a method for produciton materials with the same chemical composition as commercial materials but with higher corrosion resistance and microhardness. Originality/value: The paper presents the possibility to improve the physicochemical properties of produced material of VT 22 titanium alloy by using injection casting method.
Authors and Affiliations
A. Łukaszewicz, M. Szota
Microstructure and mechanical properties of HR3C austenitic steel after service
Purpose: The purpose of the investigations was to determine changes in the microstructureand mechanical properties of HR3C creep resisting austenitic steel after service.Design/methodology/approach: The investigations we...
The effect of CaF2 and BaF2 solid lubricants on wear resistance of laserborided 100CrMnSi6-4 bearing steel
Purpose: In this paper, laser alloying with boron and solid lubricants was used in order to produce the self-lubricating layer on 100CrMnSi6-4 bearing steel. The influence of CaF2 and BaF2 on microstructur...
Density of tin, silver and copper
Purpose: Purpose of this paper is to report on the development of a new density measure- ment cell. Design/methodology/approach: Measurement cell based on Archimedean principle and consisting of induction furnace and a...
Influence of loads in the process of laying on the resource of sea pipelines
Purpose: In the process of laying on the bottom of the sea material of the pipeline undergoes single-cycle alternating load. The purpose of the work is to determine the effect of pre-operational loads on...
Fatigue testing devices in a complex load condition
Purpose: The article presents an overview of fatigue testing devices for polymer composites in a complex load condition. This paper presents physically existing devices and which are in the design phase. Also presented...