Influence of the initial deformation of the thick plate on contact interaction with parabolic punch
Journal Title: Вісник Тернопільського національного технічного університету - Year 2017, Vol 85, Issue 1
Abstract
Calculating the strength of structural elements and mechanisms is one of the most important stages in the process of their design. Residual deformation is almost always available in the structural elements and machine parts. Resultant stress can cause fracture and accelerate some phase transitions, corrosion in particular. To improve the accuracy of calculations the residual deformations must be taken into account. In the article the solution of axisymmetric contact problem of pressure a parabolic punch for an elastic isotropic half-space, taking into account preliminary stresses is described. Besides distribution function of contact stresses and displacements for the plane boundary of semi-space was created. The authors have shown influence of residual stress on the distribution of contact stresses under the punch.
Authors and Affiliations
Hryhorii Habrusiev, Iryna Habrusieva
Keywords
Related Articles
- EP ID EP252165
- DOI -
- Views 70
- Downloads 0
Recommendations for designing cellular wall polyethylene pipes placed in the soil
Information about various Ukrainian and international national standards in the field of design and installation of polymer pipes with hollow walls is given. The strength of cellular wall polyethylene pipes placed in the...
Peculiarities of the local stresses field near the crack tip which goes out from the angular point of the broken interface
The homogeneous problem of the elasticity theory about the stress-strain state of piece-homogeneous body near the tip of the semi-infinity crack of arbitrary orientation under the plane strain is considered. The crack ti...
Analysis of the fuel and energy complex of Ukraine
The authors analyzed the prospects and directions of these components industry that are based on analysis of specific performance of the fuel and energy complex of Ukraine in general and in particular the coal industry f...
Stabilization of LEDs thermal conditions by thermoelectric modules of cooling
It is suggested to use the thermoelectric cooling modules (TCM) to stabilize the LED thermal mode. The thermoelectric cooling system has several advantages over other systems, such as: high reliability and absence of mov...
Speed change management via differential gear through epicycle
The article considers processes of continuously variable speed change management via differential transmission with a closed hydrosystem when the driving element is a solar gear and the driven - is carrier or vice versa....