Internal Mechanical Power During Cycling Using Non-Circular Versus Circular Chainrings
Journal Title: Journal of Science and Cycling - Year 2015, Vol 4, Issue 2
Abstract
Introduction: Non-circular Rotor Q-Rings have been shown to increase tangential force during the pedalling downstroke compared to conventional circular chainrings1, and due to this advantage, have been proposed as a potential aid in improving short-term cycling performance such as in BMX and sprint cycling races2. Some evidence exists that suggests this effect on pedal force may manifest in a change in metabolic cost over repeated revolutions during submaximal, steady-state cycling bouts using Rotor Q-Rings3. One mechanism by which a change in total metabolic cost may occur is via a change in the power required to move the limbs segments against gravitational and inertial forces through the pedal stroke (internal mechanical power, or IP) when compared to using circular chainrings (at the same external mechanical power, EP). Strutzenberger et al.1 reported an increase in joint muscle power of the hip when Q-Rings were used compared to circular chainrings at 70 and 90 rev · min-1, which could cause an increased IP and result in a greater total metabolic cost. The aim of this study was to further investigate the mechanical and metabolic energetics of using Q-Rings during cycling. Their effect on IP, compared to a conventional circular chainring, was assessed using a recently-proposed, multidisciplinary model for calculating IP in cycling4, which accounts for the strengths and limitations of previous biomechanical and physiological approaches. Total metabolic cost was also compared between the two chainrings for cycling over a range of workloads. Method: Ten elite male road cyclists completed 5-min cycling bouts at 80 rev · min-1 at 100, 200 and 300 W using a standard circular chainring and 52-tooth Q-Ring set in two positions: ‘#1’ and ‘#5’. Oxygen consumption was converted to metabolic power. Tangential and radial crank forces and crank position were measured using Axis Cranks (SPE, Carole Park, Australia). The x-intercept of the EP-metabolic power relationship, multiplied by the slope (delta efficiency), was equal to the physiological estimate of IP. The biomechanical estimate of IP was taken as the summed muscle joint power, determined from digitised video footage and inverse dynamics analysis, in excess of that required to apply power to the pedals (Giorgi et al. 2014). Results: Preliminary analysis of data is presented in Table 1. Data are presented as mean ± SD. No significant differences were found between the chainrings for total metabolic power or the physiological estimate of IP. Discussion: Further analysis will allow the description of changes in potential and rotational kinetic energies and muscle and joint powers throughout the pedal revolution. This information will permit the calculation of the biomechanical estimate of IP and comparisons to be made between chainrings and Q-Ring positions.
Authors and Affiliations
Giorgi, H. | The University of Queensland, School of Human Movement Studies (Brisbane, Australia).Queensland Academy of Sport (Brisbane, Australia), Andrews, M. | Queensland Academy of Sport (Brisbane, Australia), Osborne, M. | The University of Queensland, School of Human Movement Studies (Brisbane, Australia).Queensland Academy of Sport (Brisbane, Australia)
Keywords
Related Articles
- EP ID EP2918
- DOI -
- Views 366
- Downloads 29
An online survey using social media investigating the use of kinesiology type tape and McConnell type tape with clinicians who treat cycling related knee pain
Background: The Tour de France will undoubtedly showcase various cycling related injuries in its Yorkshire opening stages in 2014. Patello-Femoral Pain (PFP) is responsible for over 25% of all road cycling injuries and o...
Differences in visual information-seeking behavior between expert and novice time-trial cyclists
Introduction: Pacing can be defined as an ability to distribute available energy resources during the race (Hettinga et al., 2006). It’s a determinant of athletic performance, affected by an interaction between previous...
The effect of deceptive information about receiving cooling on pacing pattern during a 20-km cycling time trial in the heat
Introduction Cooling during exercise in the heat has been shown to be beneficial for performance (Bongers et al. 2014), but it is still unclear to what extent this effect can be contributed to actual physiological or per...
Effect of hand cooling on body temperature, cardiovascular and perceptual responses during recumbent cycling in a hot environment
Exercise in hot environments increases body temperature and challenges the function of cardiovascular, metabolic and thermoregulatory systems. Elevated body temperature as a consequence of prolonged and/or intense exerci...
The effect of aerodynamic characteristics on the drafting effect in track cycling
Since the aim of the men’s team pursuit is to accomplish a distance of 4000m as fast as possible, reducing aerodynamic drag by means of drafting can attribute in achieving this goal. Broker et al.1 quantified the average...