Investigation and improvement of high step- up converters for pv module applications
Journal Title: روش های هوشمند در صنعت برق - Year 2016, Vol 7, Issue 28
Abstract
sun is of the clean and cheapest sources of energy. Charging slight energy to electricity is carried out by PV modules. Since most electric consumers need Ac input voltage, the PV modules output voltage should be changed into Ac form. But, the voltage level of PV modules is much lower than the voltage needed in input stage of inverters. Because of large voltage level. Difference it is not possible to use the basic boost and buck-boost converters. The basic boost and buck-boost converters definitely can not be used in this applications, for, they will face extreme drop in efficiency in duty cycles closer to unity. In this paper The proposed converter is presented in order to decrease the voltage stress of coupled inductors based high step-up converters. The voltage stress in the proposed converter is lower than the high step-up boost converter with coupled inductors in identical condition. Also, soft switching condition for switches and diodes is realized by active clamp circuit, and with this technique and proper selection of duty cycle, large gain and high efficiency could be achieved ultimately. . In this paper theoretical analysis is used for analyzing the performance of the proposed converters, and in order to verify the theoretical analysis, simulated results from pspice software is provides.
Authors and Affiliations
Hamed moradmand jazi, Ehsan Adib, Bahador Fani
Keywords
Related Articles
- EP ID EP319779
- DOI -
- Views 100
- Downloads 0
Short-Term Load Forecasting of Distribution Power System for Weekdays Using Old Data
Estimation of daily load in distribution companies which is performed to present the results to the DMS, is necessary. Daily load forecasting of power systems has traditionally been considered. Because load patterns are...
Design and Implementation of a Web-based Greenhouse Remote Monitoring System with Zigbee Protocol and GSM Network
In modern and big greenhouses, it is necessary to measure several climate parameters to automate and control the greenhouse properly. Monitoring and transmitting by cable may lead to an expensive and stiff measurement sy...
Ultra low voltage and low power 4-2 compressor using FinFET transistors
A compressor is basic building blocks of many arithmetic circuits. Design of smaller area, low power consumption and high speed compressor is always in demand. As the channel length approaches nanometer scale, the use of...
Common-Mode EMI Reduction in Switching Flyback Power Supply by Implementing Cancellation Method of Heat-Sink Capacitor
Electromagnetic compatibility in switching power converters which are noise sources themselves, has a special importance. Electromagnetic interference (EMI) in the form of conducted or radiated reaches to sensitive secti...
Improved Fiber Bragg Grating Bending-Sensor Using TE/TM Modes
After the advent of optical fibers and cheap respective parts, using fiber optic sensors flourished. Bending is one of the significant parameters by measuring which, using optical fiber sensors, mechanical system mode ca...