INVESTIGATION OF BROADBAND OF SILICON-ORGANIC LIQUIDS IN MATERIALS FOR RECEIPT OF VERTICAL AND HORIZONTAL WATER ISOLATION OF WALLS
Journal Title: Вісник Національного університету "Львівська політехніка". Серія "Теорія та практика будівництва" - Year 2018, Vol 0, Issue 888
Abstract
The article presents the results of the study of the permeability of liquids produced by ZDP “Kremniypolimer” and developed mixtures of water-soluble liquids for their use in restoring vertical and horizontal waterproofing of walls by surface impregnation, by pouring into pre-drilled holes and during waterproofing repair works due to wetting of walls. It is also possible to use these liquids for the surface treatment of walls to protect them at low capillary pressures, water or protection from the effects of rain or snow because of their hydrophobic with followed coating. The main hydrophobic materials for obtaining experimental waterproofing fluids are solutions GKZ-11N and GKZ-11K 136-157 M; ETS-32; AKOR-B100. The silicon organic fluids GKZ-11N and GKZ-11K, as the main impregnating materials produced by SDP “Kremniypolimer”, do not withstand excess pressure of water more than 0,02 MPa when tested in a technique developed on the basis of determination of waterproofness of concrete. On the basis of GKZ-11N and GKZ-11K experimental waterproofing fluids No. 1 K, № 2 K, No. 1 N and No. 2 N were developed. All developed experimental mixtures No. 1 К, No. 2 К, No. 1 N, No. 2 N), as well as AQUAFIN-F, have sufficient permeability in ceramic wall materials and in cement-sand samples that simulate a mortar. The penetration of cement-sand samples is even slightly higher compared to ceramic samples. This, obviously, can be explained by the fact that firstly, cement-sand samples have a more developed pore system compared to ceramic samples; secondly, the roughness of porous walls is also different. The permeability of developed water-soluble mixtures No. 1 К, No. 2 К, No. 1 N, No. 2 N) is slightly higher as compared to emulsion or partially soluble in water (micro emulsion 136–157M (6 %), ЕTS-32, AKOR B -100), which, obviously, can be explained by the lower values of kinematics viscosity.
Authors and Affiliations
Vasyl Iliv, Y. Iliv
Keywords
Related Articles
- EP ID EP494677
- DOI -
- Views 109
- Downloads 0
Waste water heat recovery system
After heating and cooling, water heating is typically the second largest user of energy in the home. There are a lot of purposes and uses of hot water in buildings - showers, tubs, sinks, dishwashers and clothes washers...
ВИРОБНИЦТВО, ВЛАСТИВОСТІ І ЗАСТОСУВАННЯ ГАЗОБЕТОНУ НЕАВТОКЛАВНОГО ТВЕРДНЕННЯ
One of the priorities of modern construction industry is to increase the heat-shielding properties enclosing structures and reduce construction costs. Solving these problems is possible through the use in the manufacture...
ЕКСПЕРИМЕНТАЛЬНІ ДОСЛІДЖЕННЯ ДЕФОРМАТИВНОСТІ І МІЦНОСТІ ПОПЕРЕДНЬО НАПРУЖЕНОЇ ЗБІРНО-МОНОЛІТНОЇ БАЛКИ ПРОГОНОВОЇ БУДОВИ ПРОЛЬОТОМ 12 М
The paper presents only some problems of design and constraction of the bridge. The active provides the results of the research out composite muilti-span prestressed reinforced concrete beam for time building bridges. Co...
Моделювання термічного опору трав`яного шару зеленої покрівлі
Today the energy efficiency of roofs is achieved not only by the use of building materials, but also by planting. The main problems of modern urbocenoses is the lack of green areas and the inability to create them becaus...
RESEARCH OF MODIFIED GYPSUM BINDERS PROPERTIES
In the article the analysis of literary sources concerning methods of gypsum binders modification is shown. It is shown that today more and more attention is paid on the ecology of production and the maximum efficiency o...