Investigation of low-frequency chatter during machining with ball end mills
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2016, Vol 78, Issue 3
Abstract
In this study the investigations of low-frequency oscillations of technological system during machining with ball-end mill of inclined surface were made. An influence of non-linear components of cutting process on change of dynamic state of the system was analyzed. An influence of low-frequency chatter at the beginning of the cutting process on technological system transition to steady state of oscillations with frequencies close to the natural frequency was shown. Explanation of mechanics of transition process from one state to another was proposed. Multiple-factor experiments that included inclined surface machining with different values of spindle speed, allowance, direction of feed motion (upward and downward), cutting patterns (conventional and climb) were carried out. Analysis of experimental research showed that downward conventional machining process loses dynamic stability with cutting conditions, for which upward climb machining stays dynamic stable.
Authors and Affiliations
O. O. Shtehin, L. G. Polonsky, O. I. Talko
Keywords
Related Articles
- EP ID EP254204
- DOI -
- Views 110
- Downloads 0
The analysis of radiation parameters dependence of rectangular waveguide on its dimensions change
Analysis of radiation from 3 centimeter waveband rectangular waveguide at the change of the side sizes is carried out for the purpose of efficiency estimation of its use as reflector parabolic antenna exciter. Some perfo...
Substantiation of enterprises’ personnel potential characteristics
Globalization and innovation processes, which cover all the spheres of society, change the conditions for human administration in socioeconomic processes, actualizing the researches in the field of substantiation of crit...
Renewable diesel fuel and FT-fuel as alternative to diesel fuel
Biodiesel or biodiesel fuel is the most commonly used diesel alternative fuel. The high viscosity of biodiesel and the increase in nitrogen oxide emissions in comparison with diesel fuel restrict its use in diesel engine...
Improvement of construction and technology of manufacture car suspension ball bearing
The necessity of improvement of spherical articulated joints is proved on the example of a ball bearing of a forward suspension bracket of a car. The purpose of the work is to improve the design and technology of manufac...
The impact of hydrogen-bearing gas to change indexes of car engine in operating conditions
Due to lower oil and petroleum products there is a constant problem of the growing use of alternative fuels. One of the most promising is hydrogen, but its use as a self-fuel is rather difficult, but using as the form of...