Kalman Filter Based Controlled Online System Identification
Journal Title: Журнал інженерних наук - Year 2018, Vol 5, Issue 2
Abstract
In the development of model predictive controllers a significant amount of time and effort is necessary for the development of the empirical control models. Even if on-line measurements are available, the control models have to be estimated carefully. The payback time of a model predictive controller could be significantly reduced, if a common identification tool would be available which could be introduced in a control scheme right away. In this work it was developed a control system which consists of a neural network (NN) with external recurrence only, whose parameters are adjusted by the extended Kalman filter in real-time. The output of the neural network is used in a control loop to study its accuracy in a control loop. At the moment this control loop is a NN-model based minimum variance controller. The on-line system identification with controller was tested on a simulation of a fed-batch penicillin production process to understand its behaviour in a complex environment. On every signal process and measurements noise was applied. Even though the NN was never trained before, the controller did not diverge. Although it seemed like the on-line prediction of the NN was quite accurate, the real process was not learned yet. This was checked by simulating the process with the NN obtained at the end of the batch. Nevertheless the process was maintained under control near the wanted set-points. These results show a promising start for a model predictive controller using an on-line system identification method, which could greatly reduce implementation times.
Authors and Affiliations
E. N. Ganesh
Investigation of fluid flow in the space of a liquid-ring vehicle
The article is devoted to defining of hydrodynamic power losses of liquid in liquid-ring machine, in its free blade area. The losses may be compared with those in working wheel. The complexity of optimization energy char...
Investigation of critical frequencies of the centrifugal compressor rotor with taking into account stiffness of bearings and seals
In this paper the implementation of the mathematical model for rotor free oscillations of centrifugal machines is considered with the use of the computer program “Critical frequencies of the rotor”. The advantage of the...
Report on laboratory research of power-efficient triple-nozzle tuyere oxygen lancing
Based on the analysis of the advantages and shortcomings of the oxygen-converter production in Ukraine with combined oxygen and neutral gas blowing, a new combined-blowing technology by a threelevel lance has been propos...
Contact stresses on the rake face of cutting tools with PCBN in turning of hardened steel
The paper presents the results of experimental study of determination of the geometric parameters of the contact zone of the chips with the rake face of cutting tools, as well as the shrinkage of chips during the final t...
Hydrodynamics of a Liquid Film Downflow on a Flat Surface in Evaporation Conditions into a Flow of Neutral Gas
The work is devoted to the study of the gravitational motion of a liquid film under evaporation conditions into a flow of neutral gas as applied to film machines with a plane-parallel nozzle. The aim of the work is to de...