MAGNETO-ABRASIVE MATERIALS AND METHODS FOR OBTAINING THEM
Journal Title: TEHNOMUS - Year 2013, Vol 20, Issue 1
Abstract
Magnetic abrasive particles (MAPs) are crucial to ensure finishing quality and accuracy in magnetic abrasive finishing (MAF) processing. Conventional MAPs consist of ferrous particles and abrasive, such as Al2O3 , SiC, ZrO2 , B4C as well as diamond, cubic boron nitride, MgO, CeO2 or fumed silica. The MAPs can be used as unbounded, loosely bounded or bounded. Here, ferrous particles, which are mostly conventional used magnetic particles in MAF process, provide force of grinding via magnetic field. But due t o the corrosion and softness of ferrous materials, the post - cleaning of the surface finished by the MAPs containing ferrous particles becomes the most time - consuming and critical procedure in some ultraprecision MAF processing, other magnetic particles are urgent to need be developed to replace the conventional ferrous particles.
Authors and Affiliations
Băeșu Marius - Daniel, Ciobanu Mircea
Keywords
Related Articles
- EP ID EP141259
- DOI -
- Views 83
- Downloads 0
ASPECTS REGARDING THE CONNECTIONS BETWEEN CLASSICAL ENGINEERING AND VIRTUAL ENGINEERING
Virtual reality is considered one of the fundamental directions, with computers and robotics, to reconfigure the global society in this century and even further, as one solution to overcome the current structural crisis,...
THE INFLUENCE OF ENVIRONMENT TEMPERATURE VARIATION ON THE STRENGTH CHARACTERISTICS OF COMPOSITE MATERIALS TYPE “ALUCOBOND"
In this paper the authors present an analysis of the influence of temperature variation on the strength characteristics of the composite material called „ALUCOBOND”;, a material used in construction on plating exterior w...
HEAT TRANSFER IN THE COOLER - CPU INTERFACE
The increased number of requests regarding the cooling of the computers and the miniaturization of electronic components, determined the search for new solutions for intensifying the heat exchange between the processor a...
EXPERIMENTAL RESEARCH ABOUT INFLUENCE OF INCLINATION ANGLE DIRECTION UPON THE SURFACE ROUGHNESS IN BALL END MILLING OF OLC45 (C45) MATERIAL
Machining with ball end mills become a very usefull process to obtain pieces with complex surfaces. Possibilities of machining with ball nose end mills represent a adequate process to achieve surfaces with a good quality...
ABOUT NATIONAL STRATEGY OF ROAD SAFETY IN PRESENT AND FUTURE
After the year 1990, the car park and also the number of drivers have almost tripled, being in a complete contradiction with the slow development of the infrastructure, leading to an increase in the percent of material a...