Making Cast Piece Using Exothermic Head
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2009, Vol 32, Issue 1
Abstract
In this paper presents a study about cost of part obtained with exothermal heads by replacement of classic heads. This method contributes to conduct solidification of cost pieces, because exothermal heads are forecast witch mixture cover witch at connection with liquid alloys gives off warmth, effect of exothermal reactions between these components.
Authors and Affiliations
Beatrice TUDOR
Keywords
Related Articles
- EP ID EP658735
- DOI -
- Views 73
- Downloads 0
Determining the Reliability of Clincher Coolers
For any industrial entity that is put into operation, the problem of maintaining its functioning if possible, with corresponding technical and technological parameters without failure is an important issue. This is provi...
Study on the Rheology of Corn Oil Subjected to Forced Oxidation
This paper reflects a study on the rheology of corn oil in unoxidized state, subjected to forced oxidation treatment. Using the Rheotest2 system, the variation of dynamic viscosity with temperature and shear rate, using...
Quality Engineering Procedures Applied to Determine the Weight of Influence of Factors on Microtrigeneration Systems (MCCHP)
Microtrigeneration systems are characterized by simultaneous generation of power, heat and cold for small applications (<50kW) and are designed for reducing GHG and other emission degreases. The cooling generation by abs...
Research on Obtaining and Characterization of Polymeric Membranes for Wastewater Treatment
Some of the most common polymeric membranes are used in wastewater treatment. Over the years, these membranes have been studied from different points of view: their aim to improve the retention of impurities, membrane af...
Determination of the Grinding Roller Grinding Arrow in a LBC Finisher
The required profile of the cylinders is achieved by their proper correction after the change due to wear. In this paper I studied how the profile of the working cylinders can influence the profile of hot rolled steel st...