Mass Balance Reconciliation for Bilinear Systems: A Case Study of a Raw Mill Separator in a Typical Moroccan Cement Plant
Journal Title: Engineering, Technology & Applied Science Research - Year 2016, Vol 6, Issue 3
Abstract
Stream flow rates and their several compositions are measured in a typical cement raw mill separator. In order to simultaneously reconcile flow and composition measurements in this circuit, the component mass balances was included as constraints which contain the products of flow rate and composition variables in the data reconciliation problem. In this paper, the effectiveness of simultaneous procedures for bilinear data reconciliation is established, the numerical problem constraints were coded in MATLAB and a mass balance model is built. Moreover, based on the difference between the measured and reconciled data it was found that it performs optimally.
Authors and Affiliations
S. Fellaou, T. Bounahmidi
Keywords
Related Articles
- EP ID EP109420
- DOI -
- Views 273
- Downloads 0
Framework for Operational Performance Measurements in Small and Medium Scale Industries Using Discrete Event Simulation Approach
Globally, production systems must cope with limitations arising from variabilities and complexities due to globalization and technological advancements. To survive in spite of these challenges, critical process measures...
A Novel DTC Method with Efficiency Improvement of IM for EV Applications
Induction motor (IM) stator flux optimization is very important in order to get increasing running distance per battery charge of electric vehicles (EVs). This study introduces a new direct torque control (DTC) method fo...
Image Sequence Denoising with Motion Estimation in Color Image Sequences
In this paper, we investigate the denoising of image sequences i.e. video, corrupted with Gaussian noise and Impulse noise. In relation to single image denoising techniques, denoising of sequences aims to utilize the tem...
Influence of Material and Geometrical Properties of Permanent Magnets on Cogging Torque of BLDC
Aim of this study is to investigate the influence of both material and geometrical properties of surface mounted permanent magnets (PM) on cogging torque of a brushless DC motor (BLDC) by means of numerical modeling base...
Modeling Support Loss in Torsional Mode Vibrations of a Micromechanical Disk Resonator with Two L-Shaped Support Beams
In this paper, a new micromechanical disc resonator with two L-shaped horizontal support beams in torsional mode vibrations has been proposed. The proposed micromechanical resonator has been studied in the field of natur...