MASS WEAR OF ELEMENTS OF FRICTIONAL PAIR WITH ANISOTROPIC SURFACES
Journal Title: Tribologia - Year 2010, Vol 229, Issue 1
Abstract
The article deals with the influence of texture direction, as one of the structure geometric features, on the intensity of wear process of elements of frictional pairs with conformal contact. Properties of the surface layer of machine elements have been described focusing on SGS direction significance in terms of the surface layer transformation. Experimental tests results have been presented, in which such factors as: the angle of machining trace intersections on samples and countersamples (0°; 30°; 45°; 60° and 90°) and the sample and countersample pressure (300, 450 and 600 N) were accepted as input factors. The mass of samples (its changes) controlled along different friction routes was the measurement of changes occurring in the tested frictional pair with conformal contact. On the basis of carried out experimental tests it was found that the angle of machining trace intersections on samples and countersamples has a significant influence on the intensity of the wear process. Wear is the biggest for angle 0 and the smallest for angle 90. It was also found that the change gradient is smaller for higher values of the sample load. Thus in this way significance of mutual location of the sample traces on cooperating surfaces has been proved and at the same time, though indirectly, the influence of SGS direction on the intensity of the frictional pair element wear process.<br/><br/>
Authors and Affiliations
Maciej Matuszewski
Keywords
Related Articles
- EP ID EP517344
- DOI -
- Views 51
- Downloads 0
THE INFLUENCE OF THE LOAD AND JOINT CARTILAGE ELASTICITY MODULES ON SYNOVIAL FLUID VISCOSITY
During classical journal bearing lubrication the lubricant viscosity is independent of physical properties of cooperating bodies, which is well known by virtue of Hersey-Stribeck (H-S) curve presenting friction coefficie...
THE TESTING OF EXPLOITATION PROPERTIES OF ECOLOGICAL GREASES MODIFIED WITH POLYMER-SILICA ADDITIVE
In this article, the investigation results of the influence of developed additive AR (silica and polymer) on the change of rolling contact fatigue bearings lubricated with an ecological composition of grease are presente...
ANALYSIS OF THE WAVE DEFORMATION OF THIN COATINGS IN SLIDING POINT CONTACT
This paper presents an analysis of the wave deformation nature of the friction track in a sliding point contact. The object of this study was a composite nickel-molybdenum coating reinforced by the particles of aluminium...
Wpływ liczby biegów badawczych na oszacowanie rozrzutu powierzchniowej trwałości zmęczeniowej smarowanych węzłów tocznych
W artykule przedstawiono wyniki badań nad zmianą wyznaczonego rozrzutu powierzchniowej trwałości zmęczeniowej powodowaną zmianą liczby biegów badawczych w eksperymencie tribologicznym. Przedstawione rozważania stanowią k...
Zwiększenie trwałości eksploatacyjnej węzłów tarcia przez zastosowanie powłok DLC typu a:C:H oraz a:C:H:W
W artykule przedstawiono wyniki badań struktury oraz testów triologicznych powłok DLC typu a:C:H oraz a:C:H:W. Powłoki otrzymywano techniką PACVD na elemenach ze stopu Co-Cr-Mo. Analizę struktury powierzchni i jej elemen...