Mathematical Modelling, Energy and Exergy Analysis of Tomato Slices in a Mixed Mode Natural Convection Solar Dryer
Journal Title: Chemical Science International Journal - Year 2017, Vol 20, Issue 4
Abstract
This paper reports the drying kinetics of tomato (Lycopersicon esculentum) with different drying loads in a fabricated mixed mode natural convection solar dryer. The energy utilization ratio (EUR) and exergetic efficiency (ȠEx) was also estimated. Tomato slices were dried to reach the final moisture content of below 8% (w.b) from 93.67% (w.b) in a period of 20 h, 23 h and 30 h for a load of 2 kg/m2, 4 kg/m2 and 6 kg/m2, respectively. Different thin layer mathematical models were selected to fit the experimental data. According to the statistical results, the approximation of Two-term was shown a better fit to the experimental drying for the load of 2 kg/m2 and 4 kg/m2 whereas the Logarithmic model was shown a better fit for a 6 kg/m2. The maximum value of Deff was obtained as 1.14×10-10 m2/s for a loading rate of 2 kg/m2.The EUR was found to be 24.21%, 41.42% and 58.03% for the load of 2 kg/m2, 4 kg/m2 and 6 kg/m2, respectively, and ȠEx was 59%, 54% and 50% for the three load conditions of 2 kg/m2, 4 kg/m2 and 6 kg/m2, respectively. The dryer efficiency increased from 17.33% to 35% with increased in load from 2 kg/m2 to 6 kg/m2.
Authors and Affiliations
Divyasree Arepally, Sudharshan Reddy Ravula, Gulshan Kumar Malik, Venkat Reddy Kamidi
Photochemical Study for Solar Energy Conversion & Storage in Solar Cell: Yellow 5GN-EDTA System
The photovoltages and photocurrent in photogalvanic cell were studied for conversion and storage of solar energy by using yellow 5GN as a photo sensitizer and EDTA as a reductant. The observed cell performance in terms o...
Evaluation of Performance of Corrosion Inhibitors Using Adsorption Isotherm Models: An Overview
Adsorption isotherm models are an important tool for describing interaction of corrosion inhibitors with metal surfaces which they are aimed to protect. In this paper, key adsorption isotherms used in corrosion inhibitio...
Production of Mucuna pruriens (var. utilis) Proteins Isolates Using Central Composite Design and Effect of Drying Techniques on Some Properties
Response surface methodology was used to model the effect of temperature, NaCl concentration and pH on the production of protein from Mucuna pruriens seeds. The analysis of response surface graphs showed that the optimal...
Spectrophotometric Determination of Total Phenol and Flavonoid Contents of Aerial Parts of Blepharis edulis (Pers.)
Quantitative determination of phenols and flavonoids of Blepharis edulis aerial parts was carried out using spectrophotometery techniques. Gallic acid and quercetin were used as the standards for calibration for the phen...
Exploring Gmelina arborea Leaves for Biofuels and Petrochemical and Pharmaceutical Feedstocks
An investigation was carried on the chemical constituents of Gmelina arborea leaves by hydrolyzing the pulverized dry leaves with 3% sulphuric acid solution at 100°C for 30 minutes. The extract on analysis with GCMS yiel...